0
This is the type of brake pad used; When I had mine changed with a generic Firestone type place they used the standard-recommended-cheap-as-chips brand but within a week I had loads of brakedust. Took it back and had a better compound fitted and now there's little dust generated. Can't tell you the brand but recommend you just take it back and ask for something else.
What else can I help you with?
Replace brake light bulb in Saturn LS1?
There is a campaign on the brake bulbs for 2000-2003......If it hasn't been done you should get it done. The bulbs and sockets will be replaced.
How do you adjust the parking brake on a 2003 Chevy suburban?
The parking brake on a 2003 Chevy Suburban are adjusted by increasing or decreasing pressure on the spring. This is done under the vehicle, along the middle of the vehicle's frame.
How do you reset worn brake pad light on a 2003 Eurovan?
replace sensor when pad repacement is done
Adjust the parking brake cable on a 2003 Toyota Avalon?
Adjusting a parking brake cable on a 2003 Toyota Avalon is considered a major repair. The repair should not be done by a person with no prior experience because if the repair is done wrong it can be dangerous. A repair book for the vehicle should instruct the process.
Rear disk brakes on a 2003 jeep liberty?
I have a 2003 jeep liberty, i just got my rear brakes done. It cost me any where from 179.00 to 250.00. You can get it done cheaper, just dont let the brake place screw you over like they did to me.
Why does my 2003 Volkswagen jetta have no brake lights when you step on the pedal?
Two things, one the brake light switch needs to be replaced, it sits on top of the brake pedal. There is a recall for this switch for free, called an N4 recall. If you have not had this done then do so. The last thing thing is you have some bulbs out. They are single filament bulbs.
What is the minimum rotor thickness of the rear brake rotors on a 2003 gmc sierra 1500?
If you clean the rotor up alittle you will see it STAMPED on the rotor. Look at it and you will find it. That will be factory specs. If your smart, you will REPLACE the rotors and pads and you will have done a good brake job.
How do you fix a broken brake line in a 1999 GMC Sierra?
Replace the brake line, bleed the brake. top up with brake fluid. Done.
Can the front brake rotors be turned if never done on a ford focus se 2003 with 47276 miles?
Remove the rotors and take them to a machine shop for inspection. If there is not much damage they can be turned.
Where do you put break fluid in your fiat punto mia 2003?
To add brake fluid to your 2003 Fiat Punto Mia, open the hood and locate the brake fluid reservoir, which is typically found near the back of the engine bay, on the driver's side. The reservoir is usually a translucent plastic container with a cap labeled "brake fluid." Remove the cap and add the appropriate type of brake fluid, ensuring you don't overfill it. Once done, securely replace the cap and check for any leaks.
Why would 7 stop lamp fuses blow in a week on a 2003 trailblazer ext?
Because there is a known issue with the brake lamps on the 2003 Trailblazer. I own a 2003 Trailblazer and had to take it in for service on a recall due to the issue. Take it to your Chevy dealer and have them check the VIN to see if the recall was ever done.
Why does the tail lights work but not the brake lights in a 02 Saturn l200?
there could be a brake light switch located around the brake pedal, this commonly wears out on a Chevy truck The brake sockets are no good There was a campaign for updated brake sockets. Has it been done by a Saturn dealer? If not get it done and you should be fine
