Make sure the fuel pump is functioning properly. A faulty fuel pump is far more common than the switch. If the fuel pump is receiving voltage but does not build pressure, you have a faulty fuel pump. Often a failing fuel pump will cause the fuel pump fuse to fail. People tend to want to blame the computer or computer controls for problems when there is usually a more simple cause of the problem.
If a 2007 Chrysler Sebring 2.71 is not starting correctly without starter fluid being sprayed on the air filter the starter in the car may need to be replaced.
Did you check the inertia fuel switch on the floor under th glove compartment maybe it is open.
most times starter fluid is sprayed through the air filter,if this is hard to get at you can disconnect one large air hose on engine side of air box and spray in there .remember to reattach hose after starting before driving off
You do not clean any fuel filter you just replace it. If it has a filter in the tank it is a permanent filter that is only replaced when the pump is replaced.
i replaced the fuel filter and fuel pump relay. the pump runs for 2-3 seconds when key is turned. after cranking for awile, pump runs for 10-15 seconds after key is turned off. sputters a bit when sprayed w/starting fluid. it is probly your fuel injectors. get them tested.
The fuel filter is a permanent filter located inside the fuel tank. It is only replaced when the pump is replaced.
The Honeywell filter should be replaced every 8- 12 months or as needed.
take it to a mechanic?
the filter is built into the power steering reservoir . the filter cant be replaced separately . the reservoir itself should be replaced.
If the filter is mounted in the fuel tank, no. It is replaced when the fuel pump is replaced. If the filter is mounted in the fuel line it should have been replaced every 50,000 miles.
The fuel filter is in the fuel tank and is normally replaced with the fuel pump is replaced.
The fuel filter is to be replaced and not cleaned.