The brake lights and tail lights are separate wiring systems. Even some of the bulbs may have two separate bulbs in the same glass housing. If the bulbs are in fact working, then the next step would be to test the brake switch under the dash. When you depress the brake pedal the switch is pushed creating a connection to turn on the brake lights.
Your problem may be with any or all of these three items: The fuse, brake switch or bulbs in the brake lights.
where is the fuse box located on a acura
It is important to have working brake lights on a vehicle. If the brake lights are not working a person should first check the fuse, bulbs and at last the wiring.
Check BRAKE fluid level. Or is it a "tail lamp" warning? Y-THINK-Y
the brake light driver side not working
If none of the brake lights are working i would suspect the brake switch at the brake pedal.
On a 1989 Acura Integra hatch back the brake lights are reached through the hatch itself. The brake lights housing are on the rear of the vehicle. Unplug the bulbs and replace them.
The brake lights in your 1983 Nissan pickup truck are controlled by the brake light relay switch. When the brake light relay switch malfunctions the brake lights will stop working.
my lights are not working when i changed the pads on my peutgeo partner van
I don't know the Acura as they are not in the UK But it may well have safety device fitted that will not allow you to shift from park unless your foot is on the brake pedal. If this is the case, check that the brake lights are working, if they are not it may indicate a faulty brake light switch.
the connection between the battery and the brake lights
There should be a fuse for the brake lights. If the fuse is good always check the ground wire.
Get the lights fixed, of course!
Check the brake light bulbs, Check the brake light fuse, Check the brake light switch, In that order.
brake lights won't go off 1995 acura intergra
probably the brake light switch on the pedal if none are working at all
It is possible the brake light switch is broken or out of adjustment and the lights you see in back are the brake lights stuck on.
Could be a fuse or could be a bad bulb. See sources and related links below for bulb part numbers.
Check to make sure the brake lights are working when the dash lights don't - usually it's a fuse in the brake light circuit.Om both of these, it is a tedious job not ot mess something up while working in the printed circuits etc. I suggest taking it ot a garage.
check the brake light switch behind the brake pedal under the dash.
try the brake switch on the back of the brake pedal
turn signal switch needs replaced!
If you brake lights are not working on your trailblazer it could be due to a number of reasons. Your fuse could be blown, or your light may no longer work.
Your brake lights are out too! Replace the fuse.
Bulbs blown, or corroded sockets.