0
Your engine fan is not working replaced fan still not working what should you do next?
Wiki User
∙ 11y ago
egnine fan is not working on my 2006 Maxima 3.5 SL
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Replaced new washer pump and it still not working for a wrangler?
If a washer pump was replaced on a Jeep Wrangler and is still not working the fuses should be checked. The washer switch should also be checked as it could also be causing the pump not to work.
After 67000 mi your engine blew antifreeze into your oil and ruined the engine can you get the engine replaced at the cost of the auto maker?
Depends on your powertrain warranty. If it's still covered, you should be golden.
93 Pontiac Bonneville replaced Alternator twice New battery new belt and new cables and it still isn't charging What needs to be checked or replaced now?
Check ground on engine. While the engine is running, if you have a set of jumper cables handy, run it from the ground on battery (-) to the metal somewhere on the engine (that don't move). You should hear the alternator start charging as there will now be a load on it. To verify that it is working you can look at the gauge. It should now be very close to the 14 volts. This was my question I posted and no one answered for over 3 weeks. I finally found that this was my problem. I don't know why the ground cable from the battery to engine wasn't working as I replaced it after my problem started.
Pulley on a Mazda millenia?
I just had mine replaced. Cost was $205.00 with labor. Air still isn't working I just had mine replaced. Cost was $205.00 with labor. Air still isn't working
I had the thermostat radiator cap and radiator replaced on a 2001 Mitsubishi galant and it still overheats sitting at idle and while driving Any ideas on what the problem is?
have the engine timing checked. if the timing is wrong the engine will overheat, are you loosing coolant?is the fan working, is the water pump working?
Will a car still run if it has a cracked head?
Yes, it will run but the coolant will mix with the oil and eventually destroy the engine. An engine with a cracked head should not be driven until the head is replaced.
Can an engine still run withe the EGR vacuum solenoid not in working conditions?
Yes, the engine can still run with the EGR vacuum solenoid not in the working condition.
I replaced the bulb on 2000 concord and it's still not working?
Replace it again!
Replaced fans radiator sensor rfw engine light still on?
If an engine light is still on after replacing a fan's radiator sensor in a RFW engine the coolant sensor should also be checked. If the coolant sensor is bad it will send an error code to the car's computer.
You have a 2000 Malibu with a 3.1 The lifters have been replaced but there is still a ticking from the engine any suggestions?
a lot of 3.1 engines do this, if it is not severe then it should be ok...
Where is the flasher fuse located on a 1997 Buick Regal?
blower motor in dash was not working replaced it still not working now what
Your night time running lights quit working you replaced every fuse but still nothing Why?
If the night running lights have failed the bulbs should be checked. Find the bulb housings and remove the parts. After the bulbs are replaced check the lights.
