answersLogoWhite

0


Best Answer

The crank and cam sensors replace the old distributor to tell the computer when to fire the correct spark plug. The failure of either one would not prevent the engine from cranking, but would stop it from starting.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Your engine want turn over is is it the camshaft sensor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why Cadillac Escalade will not turn over after replacing camshaft sensor?

The camshaft sensor is faulty or installed incorrectly.


What causes my Pontiac 2001 to turn off while driving and engine shakes?

probably a bad camshaft sensor.


Why would a 2000 Plymouth breeze crank and not turn over?

Have you checked for fuel and spark? Camshaft sensor and or crank sensor will cause that problem as well!


Where in the check engine sensor located on the engine?

There are sensors all over the engine that can turn the check engine light on.There are sensors all over the engine that can turn the check engine light on.


What is the camshaft rotation When installing a new timing belt on a 89 pathfinder?

When you turn the engine over with the starter, which way does it turn? That is the direction it rotates.


Where can you find camshaft sesor for 1995 ford ranger 2.3L?

shaft sensor is called the crankshaft angle sensor and is located where the distribuor would normally go, which is on the passenger front side of the engine. The sensor is the black part on top that is attached by two screws. You can remove that portion safely as long as you do not turn the other part of the mechanism at all or turn the engine over or you will have to really know what you are doing to get it synched back up at the risk of damaging the engine.


How many degrees must a camshaft be turn to compelete a full engine cycles in a four stroke engine?

The camshaft would turn 360 degrees (one revolution).


Ford ikon 1.6i rocam engine will not turn over when key is used but when direct power is connected to starter to battery engine turns over.?

when the temp sensor is faulty the engine wont turn over, replace temp sensor, it is located in the termostat housing, it just plugs into it.


Car will turn over but wont start?

First, verify the spark plugs are sparking by removing one, grounding it to the engine and verify plug is firing when someone else turns the car over. If you have fire, then check crankshaft position sensor, camshaft position sensor and then fuel filter and fuel pressure.


Put in a Camshaft Sensor for a 2003 dodge stratus engine light will not turn off. Will it reset itself by driving vehicle?

If the cam sensor was the cause, the light will eventually shut off. It may take a couple of weeks.


Would a crank shaft sensor and cam sensor cause your 2002 dodge grand caravan to not turn over and or start at all?

A bad cam or crank sensor can cause a no start, but the engine will still crank or turn over.


Why wont a distributer turn?

if your talking about when your cranking the engine over with the cap off, then you have a broken distributor gear or shaft or bad camshaft gear.