check head gasket if you dnt see and coolant on floor
Whatever part is leaking is the part that probably needs attention.
If you mean that the starter keeps spinning after the vehicle starts), the solenoid/relay switch is not releasing. In the START position, the relay spins the starter to start the engine and should release when the key is moved from START to RUN. Probably needs to be cleaned or replaced.
Try adjusting your pedal
Noplace. "Set packing", yes, in Hamlet 3,4: "This man shall set me packing." "Send packing", yes, in Henry IV Part 1 2,4: "'Faith, and I'll send him packing", and in Henry VI Part 2 3,1: "'tis politicly done, To send me packing with an host of men", and in Richard III 3,2 "Ere a fortnight make me elder, I'll send some packing that yet think not on it." But not "start packing".
"was having charging system problem so alternator was replaced now car keeps flooding and won`t fire.
Have you pressure tested to rule out a blown head gasket? Does the cooling system build up full pressure and start dribbling into the overflow long before the engine is hot? If so, it could be exhaust gas leaking into the cooling system.
The expencive process from start to finish.
an explosion in the well
it will start leaking
There are many places to buy packing foam. you can start with your local post office. You can also check uhaul.com or another moving company and see if they sell packing foam.
Yes but it can take 3-10 days from her leaking milk to her whelpibg
If you have just replaced this starter then you probably have it hooked up incorrectly. If it is still the same old starter, then it has shorted out inside and needs to be replaced.