answersLogoWhite

0

What else can I help you with?

Related Questions

What does SRS button mean?

The SRS has to do with your airbag system. There is a problem that may make your airbags not work properly. THis problem needs to be checked out by the Honda dealership.


What does SRS mean?

The SRS has to do with your airbag system. There is a problem that may make your airbags not work properly. THis problem needs to be checked out by the Honda dealership.


Why alternator not charging on 1996 jimmy?

Make sure that all wires are connected properly on the correct connections. Make sure that the battery connections are clean and tight. This may help with the problem.


Why will engine light stay lite when car drives fine on a 1996 plymoth neon?

It is telling you that even though the car seems to be operating fine, something is not working properly and is about to fail. If I were you I would start with having the battery and battery connections checked out first. If you ignore it you can probably expect the failure to occur when you least want or need the problem. It really is best to get it checked out soon.


If the alternator and the battery are both new why isn't the alternator charging the battery. The fuses were checked and the connections to the battery are good. What is the problem?

just bcuz you brought it new doesn't mean it can not be defective take it back to the seller and have it checked this problem happens very often because alternators are not new anymore they are remain parts


What could be the cause of my furnace fan not working properly?

The cause of your furnace fan not working properly could be due to issues with the fan motor, a faulty thermostat, a clogged air filter, or a problem with the electrical connections.


Why does Water leaks when truck is on from top of motor passenger side?

because the tubes in your vehicle are not working properly and need to be checked the most likely problem is the tube is broke.


What could be causing the 3 way switch to not work properly?

Several factors could be causing a 3-way switch to not work properly, such as a faulty switch, loose wiring connections, or a problem with the circuit. It is important to check these components and troubleshoot the issue to determine the exact cause of the problem.


I have replaced the blower motor resistor and It blows on 1 and then it stops blowing completely what is the problem here?

Have you checked to see if your 12V dc relay under the hook is working properly?


Does the computer on a 1992 Camaro have to be rebooted when it is disconnected from the battery Car will not start checked all connections and they are ok Can't find the problem Thanks?

Any time you disconnect the battery the computer automatically reboots,


When you press the brakes a small light turns on inside the dashboard you check the brake fluid It is full What should you do?

This could mean that the light is out on the brake light. It could be a circuit is not connecting properly. Check to make sure all your lights are working properly. If its still on you should have it checked as it might be a electrical problem instead. == Answer ++ It could also mean you have a problem with your master brake cylinder. You should have your brakes checked out before you have trouble stopping.


Why does the ABS light stay on after replacing the dashboard light bulbs in a 1995 Ford Ranger?

You have a problem with the ABS system. Your brakes will still work properly but you will not have the extra safety of ABS. Have this checked out.