answersLogoWhite

0


Best Answer

i dont see y u cant but i wnt chance it i would just replace it .without it on the car might not handle right around coners it would make it lose

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Your rear sway bar mount has almost rotted off can you remove the sway bar and keep driving your car is a 1997 old lss?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the driving distance from St. Louis to mount pleasant?

Which Mount Pleasant?


What is the Driving distance NY city to rocky mount NC?

The driving distance from NYC to Rocky Mount, NC, USA is about 464.95mi / 748.27km


What is the driving distance from Indianapolis to Mount Rushmore?

The driving distance is about 1,115 miles.


Driving Distance from Rapid City to Mount Rushmore?

About 25 driving miles.


What wrench do you use to reduce the tension on the pulley to install the alternator belt on a 1995 beretta it is almost impossible to reach?

if you remove the moter Mount it is more accessible.


How do you remove a passenger motor mount?

in removing motor mount what bolts need to be removed. This is a 1998 biuck regal 3.8L, and I am not sure how to remove the motor mount.


What is the driving distance from Washington DC to Mount Rushmore?

The driving distance is about 1,640 miles.


How do you get from Watford to Mount Vernon Hospital Northwood?

by driving


How do you remove the motor mount?

pull it out


How do you change a strut mount on a Mitsubishi montero?

The bottom strut mount is connected to the frame by two retaining bolts. Remove the retaining bolts to remove the strut mount. Reverse the process to install the new strut mount.


How do you change a motor mount in a 1989 Plymouth voyager se v6 3.0L?

Well. if its your front mount, then you jack up the engine, your mount is located at the very front, at the bottom, then you remove the single bolt that goes through the mount, remove the mount, and installation is the reverse of removal.


How do you get to the freeze plugs on a 1986 Dodge pickup with a 318 engine?

For the ones on the side you may have to remove the engine mount or starter. For the ones on the back you will have to remove the transmission.For the ones on the side you may have to remove the engine mount or starter. For the ones on the back you will have to remove the transmission.