answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2008-02-05 01:08:43
2008-02-05 01:08:43

Have the two front wiring harnesses to the hub bearings replaced. This fixed the problem on my 2001 impala ls.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions



There are many different kinds of smells that could be coming from the brakes. There could be a burning smell.


your rear brakes are your emergency brakes. if your handle is coming up to much you need new brakes most likely or sometimes just an adjustment.


The Traction Control Light comes on every time you turn on the ignition. It should go off as soon as you start the engine. If it does not, then you have the traction control turned off. Turn it back on and the light will go off. If you have the Traction Control turned on and the light stays lit, then there is a problem with the traction control.


The brakes are not releasing and need to be brought back to whoever put them on.


YOU CAN TAKE YOUR BATTERY CABLES OF AND THEN PUT THEM BACK ON, THE COMPUTER WILL RESET IT SELF, BUT IF YOU HAVE NOT FIXED THE TRACTION PROBLEM THE LIGHT WILL COME BACK ON..




Check that you have the traction control button turned on.


I spent 3 days trying to bleed it myself. I finally found that with my Traction Control there is a pump. So you can not bleed if the pump is not working. The solution: Let the engine run during the whole procedure. You then get an incredible pression in the pipes. Oil is coming out for 1 foot long.


The distance a vehicle will travel between putting on the brakes and coming to a stop.


ASB translated means anti skid brakes. also known as anti locking brakes if light is coming on there is a problem in your brake system


There is a problem in the Broughams traction control circuit. Run a test of the computer for possible bad codes.


The ESP (Electronic Stability Program) light is on by default. Check to make sure you did not accidentally hit the button yourself, but the esp on means that your traction control system is functioning properly, you can turn it off and run without it but there is no advantage except that it will be easier to get into a slide or if you want to do some tricky maneuvers. If the light is a warning type and not just a notification it will mean that you have a fault in one of the systems involved in the traction control system like brakes, brake lights, speed sensors, etc. Refer to your manual, but in most cases the traction light SHOULD be on all the time.


Rotors out of round and need to be replaced or resurfaced?


Could be lube/oily substance on the pads.


LET THE ENGINE RUN.I spent 3 days trying to bleed it myself. I finally found that with my Traction Control there is a pump. So you can not bleed if the pump is not working. The solution: Let the engine run during the whole procedure. You then get an incredible pression in the pipes. Oil is coming out for 1 foot long.This is probably valid for most Ford Windstar, Aerostar, Freestar and many other Traction control cars from Ford.


When it is time to change the brakes on your 2001 Mitsubishi Montero, they will make noises. There could be a grinding or squealing noise that you will hear.


Brakes are designed in such a way as to give off a loud squeel when they are coming to the end of their useful life. If your brakes are squeeling loudly and have been for a while it is a good idea to make plans to look at them.


THE TRACTION CONTROL SENSOR IS INTERGRATED INTO THE ABS CONTROL MODULE. EBCM (ELECTRONIC BRAKE CONTROL MODULE). THIS IS LOCATED ON THE DRIVER FRONT INNER FENDER WELL. THIS UNIT HAS STEEL LINES AND ELECTRICAL WIRE COMING OUT OF IT....WHEN THIS MESSES UP ABS LIGHT AND TRACTION CONTROL DOES NOT WORK.. DEALER PRICE ON EBCM IS $850.00 PLUS LABOR!


The computer resets itself. as for the ABS-Traction control-Tire Pressure... the ABS sensors on the wheels get information for your ABS, traction control and your tire pressure monitoring system, if the ABS has a problem, it disables itself along with the traction control and the tire monitor. You have a problem with your ABS system..get it checked out



If you are having issue with the anti-lock breaking system or you are seeing the "traction" light coming on at different times, you will have take a look at the wheel speed sensor circuits. These are the main sensors that drive this system.


your back brakes are supposed to apply before your front brakes, they do this so your car does not take a nose dive every time you apply the brakes. but if it is very noticeable i would check the adjustment of your rear brakes (if you have a disc/drum setup) or i would check your proportioning valve if they are locking up


topics of service marketing for research or paper work.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.