The speaker impedance does not match the amplifier's specified speaker impedance.
Speakers are measured in Ohms not Watts. Watts is the amount of power you will be supplying to the speakers. In my 2009 Corolla the speakers can handle at least 400 Watts as this is what my OEM JBL system is pushing.
yes it will, but if you try to turn it up to loudly you may cause damage to the voice coil of your speakers
The question should be, can the two 15 inch sub-woofers handle 900 Watts? The speakers should have a power rating marked on them. If the speakers can handle 900 Watts, and they are suitably impedance matched with the amplifier, there should not be a problem.
Not unless the speakers are rated at a resistance (ohms) that is incompatible with the amp. Speakers don't generate power, the rating only tells you how much they can handle. So, speakers capable of up to 270 watts, can certainly handle 125 watts. However, if the amp is not 1-ohm stable and the speakers are 1-ohm, you could cause the amp to cut out and overheat depending on the protection mechanism of the amp.
Either too hot of an environment or too many watts going to them.
No they don't.
The power rating of speakers has nothing specific to do with ohms. look at the Watts rating printed somewhere on the speakers
Speaker wire should be sized to the maximum wattage that the speakers can handle. Use the following formula Amps = Watts divided by Voltage of the system driving the speakers.
In most cases, the speakers should be able to handle more watts than the amp can deliver. Doing it the other way around will blow out the speakers.
Well mostly it depends on the peak wattage of your stereo, if you have a higher wattage stereo I would go with speakers that could handle your stereos watts or they will distort.
The output power of home theater speakers can vary by a significant amount depending on which speakers are owned. It can range from 30 watts to 150 watts.
When purchasing car speakers you'll need to know what size you need, the amount of watts they speakers can handle and their resistance level. You'll also need to understand the resistance level and wattage output of either the stereo or amplifier that is sending the power the signal to the speakers.