0
not sure but the key is inside the fish tant thats what i want to start the truck! but the fish inside keep hurting me if you turn that remote off and try to swim the fish will hurt you be careful!
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
You can turn your key in your truck but no lights or anything happens?
Dead battery or dirty/loose battery connections.
Key turn truck on but will not turn truck off?
Probably a bad ignition switch.
Why won't My truck will not turn over when I turn the key?
Your truck will not turn over when the key is turned if the battery is dead, the ignition switch has failed, or the starter is bad. All can be readily repaired at a local mechanic or dealership.
How do you reset change engine oil light in a 2007 Chevy truck?
turn the key to the on position then pump the accelarator 3 times then turn the key off then start ur truck
Why won't my 1998 Chevy truck won't start on the first turn of the key?
my 97 doesent either solution ; turn key again.
Unlock 99 Chevy truck door?
put the key in the hole and turn
How do I fix a 1979 GMC truck I turn the key wait about 15 seconds and the truck starts it does not start when you first turn the key what do I need to replace sometime it starts instantly?
try a fuel filter change first
How do you remove idiot light on 2000 silverado?
turn key on, hit gas three times, turn key off ,start truck it should be cleared
How can I get key to turn easy to start s10 truck?
Try graphite or lock lubricant
How to Reset the security system in a 1999 suburban?
Read closely, This will take 33 mins. to do. Get in your truck with a watch, Turn key to start mode and as soon as you here the starter, turn key loose not off. Then wait 11 min. no more and no less 11 min. only After 11 min. turn key off, then repete the same steps 2 more times. Then after the last step is done, turn key off, Then start truck, Your done. If truck don't start. Then repete all the steps again, to make sure it was only 11 min. each time. BEFORE YOU DO ANYTHING CHECK THE SECURITY FUSE IN FUSE BOX.
How do you reset the oil change mesage in a 2008 Chevrolet Tahoe?
Turn the key on to the "run" postion, (key on, engine off) and step on the gas pedal 3 times within 10 seconds and then turn the key off. Then, turn the key on and start the truck. After it starts, the change oil light will flash and then reset.
What could be wrong with my truck if I do not get any power to your lights or anything when you turn the ignition key. I just changed out the starter the vehicle is a 1980 blazer fullsize?
sounds like you missed a wire replacement when you put the starter back on
