Want this question answered?
There's a plastic ring around the bulb you can remove and then twist out the base holding the bulb. Then change the bulb and twist it back in followed by the retainer ring. It's really simple (for a change). The rear spark plugs are a different story.
A ring will change shape after a while to adjust to the shape of your finger- don't worry about correcting it! have you ever looked at your finger? It isn't perfectly round! When a ring changes shape it will undoubtedly get more comfortable!
Reach behind the housing and you will find a bulb capsule with a retaining ring (plastic). Turn the plastic ring to the left (lefty loosie). After ring comes off, you pull out the capsule (with o ring).
depends on if you are replacing just the bulb or the whole assembly. with the bulb, you just unplug the plug that's attached to the bulb and unscrew the round plastic support ring, pull out then rubber grommet and there'd be a metal spring ring that you unclip and you can change the bulb. if you wanna change the whole assembly, you will need to locate all the bolts and remove them.
Undo the plastic cover over the headlights. Unfasten the connector to the bulb. Loosen the ring around the bulb then take out the bulb. Position the new bulb in the housing, then put the retaining ring back on followed by the electrical connector, then re-fasten the plastic cover.
Reach behind the headlight it self. Unplug the bulb first by depressing the plastic tab and pulling the plug down. There should be a plastic retaining ring surrounding the bulb. Turn the ring so that it unsecures the bulb. Then just pull the bulb straight back.
On the back of the headlight there is a locking ring holding the bulb in. First unplug the bulb, then turn the locking ring counter clockwise about 1/4 turn, May need to push the ring down a little bit to release it. Take out the bulb and replace being sure not to touch the new bulb with fingers as the oil in your skin will tend to make the bulb burn out quicker.
Open the hood of the Montana and fid the turn signal assembly. Dislodge the assembly from the car and wiggle the black retainer ring so that you can pull the bulb free by the blue tabs. Insert the new bulb and press firmly into retaining ring, reassemble.
unscrew locking ring 1/4 turn. pull bulb out of reflector. unplug bulb from socket. reverse order to reinstall bulb. this is the standard way to change a 9004 etc. bulb. yours should be the same.
The headlight bulbs for the Chrysler LHS are inserted in the back of the light housings. There is a twist ring that holds them in, rotate the ring to remove and replace the bulb.
No because you were born with a bellybutton that same shape and you can never change it. Ever!
When I replaced mine, I twist the black ring the the wires run through. The halegon bulb has and o-ring seals so you might have to wiggle it to remove the bulb. Remember to not touch the new bulb with your hands. You don't want to get hand oil on the bulb because it might shorten the life.