Here's a good site for you, justanswer.com/kenmore. These are appliance technicians that can answer any question asap.
fuel pump or the ignition module needs to be replaced
Nice share
check you distributer cap and rotor for wear. if so maybe that's it or bad wires.
IT's a module that controls the Deployment of the air bag & needs 2 b replaced when a new air bag is replaced.
IT's a module that controls the Deployment of the air bag & needs 2 b replaced when a new air bag is replaced.
They may have damaged ur abs sensor. that's how the atc module notices a slip.
it is not an alarm module it is called a G.E.M. module,and it located behind the radio in the dash.and to replaced it has to be reprogrammed
sounds like we are having the same type of issue, I replaced ignition Module and coil pack, and still no spark the last thing to change is the Computer.
Replace intake manifold gasket. Refer to saturnfans.com for a how-to with pictures.
I had the same problem with a 93 Jag. I replaced the ignition module, coil, crank sensor, and even the ECU computer and I still did not have any spark. I was stumped and studying the wiring diagram I replaced the ECM Main Relay that was the problem, it fired right up. The ECM Main Relay on the 93 is located in the passenger side of the engine compartment on the firewall and it is the farthest outboard relay. Simple fix. I sure hope this helps someone out there
i have a 96 ,i replaced the module the other day,i found it next to the battery
The computer needs replaced.