0
if your engine is already on and your turn the ignition key again what damages can be done?
Wiki User
∙ 10y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the ignition and distributor located on a 1990 Chevy Celebrity?
The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.
What happens if a car is already started and you turn the ignition to start it again?
you burn out your starter or your fly wheedl
Did formatting system repeatedly damages system?
yes it does damages the system because the hard disk gets worn out by formatting again and again.
What damages if the car overheats?
It can cause the head gaskets to blow. This must be repaired before driving again. If really overheated, you can blow your engine. This would need replacing.
What Damages make a person whole again?
Compensatory and Punitive
What components control ignition timing advance?
Need to know what year and engine size and model to answer right.Please ask your question again with that infomation. THANK YOU> NEUTZ
How can you reset the fuel pump that was disabled after having bypassed the PASSLOCK security system?
on a 99 TahoeUnlock the Tahoe driver's door and insert the key into the car's ignition.2 Turn the key to the "Run" position. This is the position where the ignition is on, but the engine is not. Wait five seconds for the security light to go off, then crank the engine. If the engine does not crank, continue to step 3.3 Leave the ignition key in the "Run" position for 90 seconds, or until the security light stops flashing again. Retry cranking the engine.4 Remove the key, exit the car and lock the doors if the engine doesn't start. Unlock the car again and repeat step 3 again. If the Passlock still won't reset and you can't start your car's engine, you may have a faulty or non-programmed car key. In that case, you must contact the Chevrolet dealership and get them to reprogram or replace the key
How do you reset the check engine light on a Honda CRV?
On most vehicles, after the problem is taken care of, the check engine light resets automatically after the ignition is turned off and then the engine is started again. If you have fixed one problem, a second problem probably exists.
2001 spectra check engine flashing running rough computer says cylinder 3 misfire replace plugs runs great for 5-7 miles then check engine flashes again and starts running rough again whats up?
I think your problem is either in high voltage cables or in the ignition coils. Since you have two ignition coils for 4 cylinders and missfire in one, the problem is in the cables.
Why does 1991 passat splutter and die when engine reachs normal operating temperature and won't start again until engine cools?
Check the ignition coil. At cold coils generally operate properly, when the coil heats a failing unit will start to break down and fail causing misfiring and poor engine operation. Second check for a failing ignition controller in the distributor.
When you start to accelerate your truck jerks why is this?
Ignition is most likely culprit, plugs, wires, cap, etc - engines that run smooth at idle but break down under load again are usually ignition related. Year / model / engine would help determine where to start... I'd be looking into ignition issues.
Is there any search engine that searches using images but not strings?
Yes actually there. I predict you have already used Google, but please, try again!
