0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Define direct shear stress?
Shear force is a load (pounds, or newtons) in plane of the object which produces shear stress ( pounds per sq inch, or Pascals). Shear force is related to shear stress as STRESS = FORCE/AREA
Direct shear test of metal specimen?
what the neccecities of shear test of brass & mild steel
What the symbol of shear?
The mathematical symbol for shear is the greek letter tau - which is similar to the English letter "t". Shear stress is given in Pascals or Megapascals, as this denotes pressure - force over an area - which then leads to the applied shearing load.
Why is graphite low shear strength?
Graphite has low shear strength due to its laminar lattice structure and weak bonding between the layers which allow graphite to slip in layers resulting in low shear strength. - Dr. Aditi Kulshrestha
What is shear strengh steel st52?
96Mpa
What might happen if you over tightened your piston connecting rod on a Briggs and Stratton?
You might have weakened the bolt, causing it to shear when you run the engine
How would the timing get knocked off of 5 hp Briggs and stratton?
If it back fires or it gets jammed up it may have shear the key on the shaft under the fly wheel that would put it out of time.
What would hitting a tree stump do to a push lawn mower?
a gas mower i take it, you can bend the shaft, shear the keyway, and twist the shaft,
What causes a transform boundary?
Shear
Wind shear can cause a formation of what?
wind shear causes the formation of a tornado if you have a strong thunderstorm.
What causes a strike slip fault?
shear
What exactly causes shear?
to much stress on the product, there are many types of 'shear' but in its basic form the ammount of stress/preasure on the material causes it to fail
How a 6.5 ohc Briggs and straton won't start fast after 3-5 prime pumps have to pull start over 8-10 times to get it run once started runs well with power but if you stop it won't start fast again?
It could be that the shear pin is damaged or bent and the engine is "out of time" when it gets to TDC. The flywheel will have to be removed to get to the shear pin. The shear pin is the aluminum pin that fits in the keyway of the flywheel and the shaft. It is made of aluminum and meant to break, bend, or shear when the mower blades strike a solid object while rotating. The breaking, bending, or shearing of the pin helps prevent the engine from being damaged or at least minimize engine damage at impact.
What is shear stress in science?
Shear stress in science is a type of stress in which an object that has a force acting upon it is applied to skew. This causes shear strain, which can change the shape of the object.
What type of fault is created by shear stress?
Shear stress causes Transform faults, in strike-slip zones of conservative boundaries.
What tornado creating ingredient causes the air to rotate?
Wind shear.
Briggs and Stratton 4.5 HP required oil?
You should use a 30-weight motor oil, NOT a multi-grade such as 10-W-40. Use of multi-grade oil will increase your oil consumption considerably. Check your owners manual, nearly all Briggs engines made in the last 10 years recommend a multi-viscosity oil, namely 10w30. However, if not used below 40 degree temperature's, 30w detergent oil is fine as it is shear stable (will not degrade to a 20w under high heat).
