0
What else can I help you with?
What are car stereo wiring color codes for a 1989 Oldsmobile ninety eight?
looking for the car code for a ninety eight 1989 oldsmobile
Where do you put power steering fluid in a 1989 Oldsmoblie Cutlass Supreme?
Where the stick is.
Where is the horn relay located on a 1989 Oldsmobile Ninety-Eight?
under kick panel on passenger side
What refrigerant used in a 1989 Oldsmobile ninety eight?
Originally R-12 Should be converted to R134
How do you change the headlight on a 1989 Oldsmobile ninety eight?
You have to stick your hand behind the headlight. And there is a piece of plastic on the back side if the lamp. Twist it to the driver side fender and it out and you will see the light bulb.
How do you change the harmonic balancer for 1989 ninety eight Oldsmobile regency?
take off the right wheel and the cover wall and you wll see it
How much horsepower is in an 89 Oldsmobile ninety-eight?
My 1993 Olds Ninety-Eight 3800 has 290.AnswerUnless you have a supercharged engine,horsepower ratings for the 3800 (3.8 liter)V6 is around 170. The naturally aspirated 3800 Series II is rated at 205 HP while the supercharged version is rated at 240 HP.The engine in the 1989 ninety eight is the LN3 V6 which is rated at 165 HP
Where is the fuse box on a 1989 Oldsmobile royale regency ninety-eight?
The 1989 Oldsmobile Regency fuse box is located beneath the drivers side dashboard. The fuse box will be near the emergency brake release.
What is code 27 for the 1989 ninety-eight Oldsmobile?
Code 27 for the 1989 Oldsmobile Ninety-Eight refers to a diagnostic trouble code related to the engine control module (ECM). Specifically, it indicates a problem with the vehicle's fuel system, often pointing to issues such as a faulty fuel injector or problems with the fuel pressure. It's important to diagnose further to determine the exact issue and ensure proper vehicle performance.
How do you replace heater core on 1989 Oldsmobile ninety eight regency?
To replace the heater core on a 1989 Oldsmobile Ninety Eight Regency, start by removing the dashboard and the center console to access the heater core housing. Drain the coolant from the radiator, then disconnect the heater hoses from the core. Remove the screws or clips securing the heater core, replace it with the new unit, and reassemble the components in reverse order. Lastly, refill the coolant and check for leaks before starting the vehicle.
How do you replace a water pump on a 1989 Oldsmobile Regency Ninety-Eight?
To replace the water pump on a 1989 Oldsmobile Regency Ninety-Eight, first disconnect the negative battery cable and drain the coolant from the radiator. Remove the serpentine belt and any components obstructing access to the water pump, such as the alternator or power steering pump. Unbolt the old water pump and clean the mating surfaces before installing the new pump with a new gasket. Finally, reassemble the components, refill the coolant, and reconnect the battery.
Does a 1989 Oldsmobile ninety eight 3800 series engine have a plastic timing gear?
Yes, the 1989 Oldsmobile Ninety-Eight equipped with the 3.8L (3800 Series) engine typically has a plastic timing gear. This design was common in many GM engines of that era, which used plastic timing gears to reduce noise and weight. However, it's important to note that over time, these plastic gears can wear out or degrade, potentially leading to timing issues. Regular maintenance checks are advisable for older vehicles.
