0
What else can I help you with?
How do you change a Harmonic Balancer on a 92 Ciera?
To change the harmonic balancer on a 1992 Oldsmobile Ciera, first disconnect the battery and remove the serpentine belt. Then, unbolt the harmonic balancer using a socket wrench and puller, if necessary, to detach it from the crankshaft. Clean the mounting surface, install the new balancer, and torque it to the manufacturer's specifications. Finally, reattach the serpentine belt and reconnect the battery.
How do you change harmonic balancer on 1991 buick lesabre?
The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.
How do you change a harmonic balancer on a 1999 Montana?
To change the harmonic balancer on a 1999 Pontiac Montana, first, disconnect the battery and remove any obstructions, such as the serpentine belt and crankshaft pulley. Use a harmonic balancer puller to carefully detach the old balancer from the crankshaft. Once removed, clean the crankshaft and install the new harmonic balancer, ensuring it is properly aligned. Finally, reassemble any removed components and reconnect the battery.
How do you change a crankshaft position sensor in a 1997 Oldsmobile Regency?
1. remove positive battery cable. 2. Remove the serpentine belt. 3. remove harmonic balancer. 4. remove timing cover. 5. remove wiring connector from c.p. senser. 6. remove c.p. senser. 7. reassemble in same order as disassembled.
How do you change a harmonic balancer on a 2001 impala?
take the serpentine belt off and then take the crank pulley off the balancer and then you will need a puller to get the balancer off the crank.
How do you replace the crank position sensor on a 92 Olds Cierra 3.3L and can it be done with out pulling the harmonic balancer?
The harmonic balancer must be removed to change the sensor because the crank position triggering rings on the back of the balancer are entwined with the pick-up, Sorry
How do you change the harmonic balancer seal on a Toyota truck?
To change the harmonic balancer seal on a Toyota truck, first, disconnect the battery and remove any components obstructing access to the harmonic balancer, such as the serpentine belt and crankshaft pulley. Use a puller to carefully remove the harmonic balancer from the crankshaft. Replace the old seal with a new one, ensuring it's seated properly, then reassemble by reversing the removal process, tightening bolts to the manufacturer's specifications. Finally, reconnect the battery and check for leaks.
How do ichange harmonic balancer on driveshaft of 1997 ranger?
change car buy new one
How do you change the pulsar harmonic balancer when the bolt is a bit rounded?
have you tried a 6 point socket?
How do you change the harmonic balancer in a 1994 buick lesabre?
I tried to change the harmonic balancer of my biuck lesabre 1994, but i can't remove the old one, the bold in the center is very , very tight and i don't know the type of screw, right or left turn.
How do you change a harmonic balancer on a 1999 Jeep Cherokee 4.0 L?
Remove the belt. Remove the bolt that attaches the harmonic balancer. Rent or purchase a harmonic balancer puller. Follow the Instructions with the puller and remove the old balancer. Install the new balancer making sure to line up the keyway, a little oil helps. Put the retaining bolt back in and tighten to manufacture specs.
1989 Oldsmobile Brougham Regency 98 change spark plugs?
where would the spark plugs at on a Oldsmobile 1989 engine
