answersLogoWhite

0

Air in the brake pipes. Old fluid. Worn seals in master cyclinder. Overheated brake pads and discs. If the pads are new they might not be bedded in yet; especialy if the discs are worn or ridged or scaled up.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Which bolt to take out of the caliper when changing brakes on a Chrysler Pacifica?

THERE ARE TWO BOLTS ON EACH SIDE OF THE CALIPER REMOVE THOSE AND PULL THE CALIPER OFF


Dodge 2500 brake caliper problems?

what problems,need more information


Changing the front brakes on a 1997 mazada 626 do i have to pull the entire caliper off?

you have to unbolt the caliper off the rotor, but not from the brake fluid line.


How do you change the brake caliper on a Mercury Sable - Ford Taurus?

Changing the caliper is an extension to the changing the brakes procedure.The 'extension' is to disconnect the brake line/hose from the caliper.Next extra step is to bleed the brakes - since the new caliper is going to be full of air when you first hook it up.See "Related Questions" below for more extensive coverage of the procedures...


What is meant by backlash in the vernier caliper?

Backlash in a Vernier caliper refers to the amount of free movement or play in the sliding jaws when changing direction, which can affect the accuracy of measurements. It is important to minimize backlash by properly adjusting and maintaining the caliper to ensure precise measurements.


Changing rotors on 99 Malibu?

take off wheel, then take off caliper by the 2 mounting bolts. do not let caliper hang by brake hose, tie up to spring if possible so your brake hose does not get broke. take off caliper mount, then slide rotor off. when putting back on caliper, push caliper cup in to bore, all the way with a c clamp. put caliper holder back on. then put brake pads in caliper. place caliper over rotor, and tighten down.


Why does your caliper stick?

Because it's sticky.


Changing rear brake pads on a cadillac?

remove caliper. may be chrome cap on top bolt you have to remove to get to the 8mill bolt. slide off caliper and press in piston. change pads and reinstall


Im changing brakes on 1992 f150 do i have to take the master cylinder cap off to push in the caliper?

no you dont have to---BUT its adviseable


How do you fill the break fluid in scooter's front wheel?

Need more info. are you replacing the caliper or just changing the fluid?


How do I find a brake caliper repair store?

If you wanted to find a good place to fix a faulty caliper problem, then you would have to visit Goodyear. They are really good when it comes to mechanical brake problems.


How do you push piston back in caliper when changing pads on a astra with ABS?

get a large pir of grips and squeeze should go back in.