From the fuse panel, hot in accy or run, comes a light blue with black wire, to the tailgate window switch in the dash. From this switch, two black wires go to ground, and a pink with light green and a pink with light blue wire go forward to the tailgate key switch. From the fuse panel, hot at all times, comes a black with white wire, also to the tailgate key switch. From the tailgate key switch comes a yellow with red wire directly to the tailgate window motor. Also from the tailgate key switch comes a tan with black wire, to a tailgate latch switch, and from there a red with yellow wire to the tailgate window motor. That latch switch functions to keep the window motor from working if the gate is not completely closed, and from what I hear, with wear and tear over time, begins to malfunction just from getting out of reach. If your window quit working, start there. Otherwise, it would be impossible to explain how those switches work together in the same circuit without a drawing, so I must recommend the website of helmdirect, for the electrical and troubleshooting manual I'm referring to, which I bought there, for the same vehicle. Best $25 I've spent.
Use the circular key, once inserted into tailgate, turn key to the left of right to make window go up and down..
check any bronco group web site, membership is usually free and they have all the schematics for the back window wiring and more
To remove the rear tailgate window switch on a 1995 Ford Bronco, first, disconnect the vehicle's battery to ensure safety. Then, use a flathead screwdriver or a trim tool to gently pry off the switch cover from the tailgate panel. After removing the cover, you can access the switch's mounting screws; unscrew them and carefully pull out the switch from its housing. Finally, disconnect the electrical connector from the back of the switch to complete the removal.
this is the biggest pain i ever had to do when i had my bronco... but its simple, just take the plate off of the inside of the tailgate (tailgate could be up or down, down is easier), find the motor, unplug it and remove the couple bolts that are holding it in. careful not to cut yourself there isn't much room to work. the hardest part is getting it back in. good luck!
To fix the rear window on a 1995 Eddie Bauer Bronco, first, check the window motor and switch for functionality. If the motor is faulty, it may need to be replaced. Inspect the window track for any obstructions or damage; clean or repair as necessary. If the wiring is damaged, repair or replace it to ensure proper operation.
It's about this wide and about yay so tall...
Open the tailgate, remove the retaining cables from the studs, pull out on the passenger side of the tailgate.
big hammer
Yes , there was a 1995 full size Ford Bronco ( the last model year was 1996 )
You can find a wiring diagram for the rear window defogger in a 1995 Ford Escort LX Haynes repair manual. The book is available at most auto parts stores.
the window has to be all the way down
open tailgate. unclip the cables that hold tailgate level they will unclip from the top anchor post without using any tools.then lift tailgate from left side so as tailgate hinge comes up from pivot point. then slide tailgate little to the left and you should have tailgate in your hands