First of all, it's not a "bulb" but a florescent tube and ballast assembly. To remove and replace, you must first remove the plastic covering on the inside of the rear hatch. Then it's just a matter of removing the 0ld and putting in the new.
how do you replace the fog light bulb on a 2003 ford explorer.
replace head light switch on 93 ford explorer
you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light. you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light.
Open the entire back hatch, and unscrew casing, and replace bulb. Now redo what you've undone.
How to replace a brake light on a nissan Tiida hatch back.
To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.
You replace the hazard light fuse in a Ford Explorer in the fuse panel box. The fuse panel box is located under the vehicle's hood.
You will probably find it is a mercury switch in the wiring bundle.
To replace the interior rear hatch light in a VW Touareg, first, locate the light housing on the interior of the hatch. Use a flathead screwdriver to gently pry off the light cover. Remove the old bulb by twisting it counterclockwise, then insert the new bulb and reattach the cover by pressing it back into place. Finally, test the light to ensure it functions properly.
To replace the lower hatch brake light on a 2002 Lexus RX 300, first, open the rear hatch and locate the plastic cover over the light assembly. Remove the cover by gently prying it off with a flathead screwdriver. Once exposed, twist the light socket counterclockwise to remove it, replace the old bulb with a new one, and then reassemble by reversing the steps. Ensure everything is securely in place and test the brake light to confirm it works.
to replace the tail light open the hatch look on the side of the light you will see two screws remove them. Pull the light out, take the three bulb out ken
Raise the back hatch there is two screws that hold the tail light on (2002 ford explorer) remove the tail light and twist out bulb housing , pull release clips and remove bulb. Install bulb in reverse.