answersLogoWhite

0

Could be just about anything without more information. Check your oil level first.

User Avatar

Wiki User

∙ 17y ago

What else can I help you with?

Related Questions

How do you reset the check engine light on a 1994 Chrysler Cirrus?

The Chrysler Cirrus did not come out until 1995. You reset the check engine light with a scan tool or by unhooking the battery. If you have not repaired the cause of the code the light will come back on.


Disconnect check engine from 2000 Chrysler Cirrus permanently?

You can not disconnect the check engine light.


How do you know if a 1997 Chrysler Cirrus has a factory alarm?

When you lock the doors, there will be a small red light on the dash that flashes to tell you the alarm is arming.


2000 Chrysler cirrus what would make the check engine light flash?

A flashing check engine light is an indication of a severe engine misfire.


What would cause the check engine light not to light on a 1997 chrysler cirrus?

The bulb is burnt out or has been removed.


How do I check the Check Engine Light Error codes on a 1997 Chrysler cirrus?

With a scan tool.


How do you turn off the check engine light on a 1998 Chrysler cirrus?

You need a code reader to reset & plug into port.


Where is the horn on a 1997 Chrysler cirrus?

Behind fog light on passenger side


How can you find out what is wrong on a 1996 Chrysler cirrus lxi when the check engine light comes on?

go to an auto parts store most will put on computer for you for free


What code is it when the service engine light flashes 3 flashes pause 2 flashes mean what code is it when service engine light flashes 2 flashes pause 1 flash?

32 and 2132 and 21


How do you reset the check engine light on a 2000 chrysler cirrus?

To reset the check engine light on a 2000 Chrysler Cirrus, you can disconnect the negative battery cable for about 15 minutes, which will clear the stored error codes. Alternatively, you can use an OBD-II scanner to clear the codes after addressing any underlying issues. Always ensure that the problem that triggered the light is resolved before resetting it to avoid potential engine damage. After resetting, reconnect the battery or turn off the scanner, and the light should be off.


How do you replace the dome light light bulb in a 1999 Chrysler Cirrus LX?

If it is like my 2000 Cirrus, I use the key to pop the cover off, then just remove and replace.

Trending Questions
Both backup lights on your 2002 Ford Focus zx3 do not work The fuse is fine you replaced it just to be sure and the bulbs are fine replaced those as well What else could it be and how do you fix it? Where and how many Oxygen Sensors are on a Dodge Ram 3500 V8 5.9L Truck? What is the weight of a 1962 Chevy truck? If after filling the gas tank and driving 100 miles the tank reads less than half could it be the gauge or something else? What is the bolt pattern of the 2002 Pontiac Grand Prix? What is the freon capacity of a 1988 Chevrolet r3500 crew cab pick up? What kind of fuel does the 2012 Dodge Charger use? Where is the fuel pressure regulator located on a 1997 Chevy blazer? How do you get into a Chevy Corvette that has a dead battry and i don't have a key for? 2000 windstar sel radio not working? What is the normal water temp in a 305 V8 Chevy engine? Does it matter to install header gaskets on a 350 Chevy engine or not? 2003 Dodge Ram 1500 and the left brake light will not work you have changed the bulb and checked the fuses all are good The right brake light works fine What else could be the problem? Where is starter SOLENOID 1997 Ford Thunderbird? Where is the fuel pump located on a lincoln continental? What is rotation for a 79 Chevy distributor in a 305 engine? Will a 1992 Dodge Dakota wiring harness work on a 1990 Dodge Dakota truck if the 1990 had a 3.9 liter v6 and the 1992 Dakota has the 5.2 liter v8? Where do you add freon to a 1998 Jeep Wrangler 4.0 And is there a specific type that must be used? Will 265-70-15 tires fit on 10 wide wheels? What is the oil capacity for an oil and filter change on a 1997 Buick century custom?