yes it has one
Before changing the radiator on a 2001 Pontiac Montana the coolant must first be drained. After the drain remove the radiator mounts, fans, and hoses. Pull the radiator upwards.
2001 Pontiac Montana?
To remove the radiator from a 2001 Pontiac Montana, begin by disconnecting the negative battery cable and draining the coolant from the radiator. Next, remove the radiator hoses and any electrical connections. Unscrew the mounting bolts that secure the radiator and carefully lift it out of the engine bay. Be sure to replace any gaskets or seals during reinstallation.
Raise and support the vehicle. Remove the radiator air deflector bolts. Remove the radiator air deflector.
How much refrigerant is needed recharge ac on a 2001 Pontiac montana
2001 Montana has an electronic transaxle. There is no vacuum modulator. The 2001 Montana has an electronically controlled transaxle. There is no vacuum modulator.
No
under the antifreeze compartment
To remove the thermostat from a 2001 Pontiac Montana, first, ensure the engine is cool and disconnect the negative battery terminal. Then, drain the coolant from the radiator and remove the upper radiator hose connected to the thermostat housing. Unbolt the thermostat housing, remove the old thermostat, and clean the mating surfaces before installing the new thermostat. Finally, reassemble everything, refill the coolant, and reconnect the battery.
The 2001 Pontiac Montana block heater cable can be found in the front of the vehicle. You can access the block heater cable through the front grill.
There is only one fuel pump fuse on a 2001 Pontiac Montana. It can be found in the engine compartment near the firewall at the rear of the compartment.
On the coolant overflow bottle