0
assuming you have an automatic transmission, the most probable cause of your shifting issue is a faulty valve body. The valve body houses the control solenoids for shifting. The valve body also directs fluid to its correct location when needed. there are some instances when replacement of the solenoids can cure the issue. If you have access to a OBD II scan tool. check for stored codes for faulty solenoids. The Saturn dealer sells a valve body package complete with instructions on how to replace the unit for around $700
What else can I help you with?
You have no reverse gear drive works fine what could be wrong?
Mis adjusted shift linkage, internal failure
Where is the shifting solenoid on a 95 ford escort and how do you replace it?
I have a 95 escort , 1.9 liter engine . The car runs fine, goes in reverse fine and into first fine, BUT will not shift into second. I changed the fluid and filter. There were no shavings on the magnets or in the bottom of the pan. The fluid was clean and did not smell burnt.
Your 1992 Toyota Paseo 5spd doesn't like to go in reverse as long as you don't go in reverse it shifts fine but after it's been in reverse it doesn't want to shift unless you turn the car off and on?
Back into parking spaces. How with no reverse??????? Try again
Why do 1993 protege go forward in reverse gear?
The car is not actually in reverse, it only looks so because the linkage between your transmission and the shift lever is broken or stretched. Most likely the tranmission is fine, but the linkage will need to be looked at or replaced.
Dodge 2002 neon will not shift into reverse- all other gear are ok- what do you think is the problem?
I just fixed a 2002 Dodge Neon that would not shift up it was stuck in low gear replaced TCM now trans is working fine
Ford Explorer automatic transmission does not catch reverse gear but works fine in all other gears What can be the problem?
Reverse is usually the first to go, followed by first gear. Time for a transmission rebuild.
2001 Ford Ranger V6 The engine starts fine But When you try to shift into drive or reverse the shifter won't move Please tell me I don't need a new transmition?
Assuming that you are pushing on the brake pedal ( it has a brake-shift interlock where you have to push on the brake pedal to shift out of park ) it sounds like a problem with the brake-shift interlock . Click on the link below , click on Owner Guides , the Owner Guide ( which includes the instructions on what to do if the gear selector won't come out of the park position ) can be viewed online
Why does a Pontiac gtp spin on take off revere is fine?
it has alot of torque. the reverse gear is different than first.
1999 Chrysler Concorde that will not shift out of low gear and the check engine light is on will go in reverse fine just started this what could be wrong?
The TCM (trans computer) has detected a problem and set a code. This causes the trans to go into safe mode and not shift. Have it checked for codes.
Why would a transmission be slow to shift to reverse but otherwise work fine in a 4WD 1992 Ford Explorer?
Quite possibly you may need the trans serviced. Probably has a partially clogged trans filter.
What does it mean if your 1999 Chrysler sebring jxi will go in reverse fine but wont get out of 1st gear going forward?
You need to have the system checked for codes. Any electrical problem with the trans can cause a no shift.
Why would the reverse lights not work on 2001 Nissan Frontier even after replacing bulbs and checking all fuses while Brake and Turn signal lights work fine?
Hopefully, you used a 12v. test light. Did you check the wiring and connections at the reverse light switch on the transmission. This could also be called the back up switch. There may be such a switch on the shift selector. Buy a Haynes or Chilton Total car care manuals.
