Turn key on DO NOT START, Push the gas pedal all the way to the floor 3 times. then turn key off and then start engine.
The 2003 Chevrolet suburban requires five quarts of oil in the motor. The oil filter should be filled with oil, when changing it.
The oil pressure sensor, on your 2003 Chevrolet engine, is located on the front of the engine, just above the oil pan. The pressure sensor will have two wires going to it.
Engine oil with filter change 6.0qts
There are a few different reasons for oil loss in a 2003 Suburban. This could be because the oil filter needs to be replaced or the oil drain plug needs to be replaced.
To reset the oil life system....pretty simple. Turn your key to the on/run position. All the lights on your dash board should come on. Quickly press the gas pedal 3 times and the message will read oil life system reset. Turn the key back to the off position and your done.
A 2009 Chevrolet Suburban will take approximately 5 quarts of oil. The oil can be purchased at any auto parts store such as Advance Auto.
how do you reset computer on a 2003 ford explorer after oil changes
For a 2003 Chevrolet Suburban with a 5.3L engine, it's recommended to use 5W-30 motor oil. This viscosity provides good engine protection across a range of temperatures. Always check the owner’s manual for any specific oil recommendations or specifications, especially if the vehicle operates under extreme conditions.
For a 2003 Chevy Suburban (all engine sizes), the recommended viscosity is 5W30.
Here's a link I found that helped me reset my Engine Oil Life indicator: www.obd2.com/support/reprog/downloads/gm/gm-reset_oillife-trucks.pdf Find your vehicle and follow the instructions listed beneath. Good luck. Anna in Wyo
The bottom of the engine. There is a plug that you drain the oil out of. that plug is in the pan.
5 qts. with new filter.