sorry, i dont know where else to put this information...
just as title says. one day after i had the oil changed, i had noticed that the pcv vacuum line was disconnected. when i hooked it back up, the car shut off. i had the valve replaced and the line and the box it connects to replaced. the problem still exists. ive been driving it around with it unhooked but it eats up much gas than usual. any ideas? thanks!
Do you have a MIL (check engine) light illuminated in your dashboard? if so, you should take it to autozone or advance auto parts and have them pull the codes on the car. You could even spend the money on a OBDII code reader to retrieve the codes on your own. This code would then allow you to identify the sensor that is malfunctioning.
Its located on the passengers side near the floorboard and the firewall..............
The 1997 Chrysler Sebring radio amplifier does have an in-line fuse. The in-line fuse will be in the radio wiring harness.
The shut off valve.
it shuts off and the tv screen sais line
To add Freon to a 2004 Chrysler Sebring, locate the low-pressure service port, which is typically found on the larger diameter aluminum line leading to the AC compressor. Remove the cap from the port and connect the refrigerant can's nozzle. Make sure the AC is set to the maximum cooling setting before adding Freon. Always check the system's pressure with a gauge to avoid overcharging.
The hot wire is typically connected to the line terminal.
Either its dead or line is busy
series connected
The filament connected to the Z line in a muscle cell is thin filament, specifically actin filament. Thick filaments (myosin) are connected to the M line in the sarcomere.
Circle
wow. line graph.
Check the gas line disconect the line going to the carb and blow on it or let it run some out of the line to see if its getting gas.