answersLogoWhite

0

The hot wire is typically connected to the line terminal.

User Avatar

AnswerBot

4mo ago

What else can I help you with?

Related Questions

How do you tell which is the line wire and the load wire?

The line wire will be hot and carrying power when the breaker is on. The load wire will not be hot and will have no voltage on it until it is connected with the line wire.


What are the differences between load wire and line wire in electrical systems?

In electrical systems, the load wire carries the electrical current to the device being powered, while the line wire brings the current into the system from the power source. The load wire is typically connected to the device, while the line wire is connected to the power source.


When you have two 6 volt batteries in series with load on them what order do you disconnect them safely?

Establish which terminal is connected to ground and disconnect the wire from the terminal. Disconnect the terminal on the other battery that is connected to the load. Finally disconnect the loop between the batteries.


What is the difference between a line and load in a light switch circuit?

In a light switch circuit, the line is the wire that brings power into the switch, while the load is the wire that carries power from the switch to the light fixture. The line wire is typically connected to the power source, while the load wire is connected to the light fixture.


What is the difference between the line wire and load wire in electrical circuits?

In electrical circuits, the line wire carries the incoming electrical current from the power source, while the load wire carries the current to the device or appliance being powered. The line wire is typically connected to the power source, while the load wire is connected to the device that needs electricity.


What is the difference between light switch load and line connections in a circuit?

In a circuit, the line connection carries the electrical current from the power source to the light switch, while the load connection carries the current from the light switch to the light fixture. The line connection is typically connected to the hot wire, while the load connection is connected to the wire that leads to the light fixture.


How can I identify the line and load wires in an electrical circuit?

To identify the line and load wires in an electrical circuit, you can use a voltage tester to determine which wire is live (line) and which wire is connected to the device (load). Make sure to turn off the power before testing and follow safety precautions.


How to wire a rockford fosgate t500.2 in 2 ohm?

To wire a Rockford Fosgate T500.2 amplifier to a 2 ohm load, you will need to connect two 4 ohm subwoofers in parallel. Each subwoofer's positive terminal should be connected to the amplifier's positive output terminal, and each subwoofer's negative terminal should be connected to the amplifier's negative output terminal. This will create a 2 ohm load for the amplifier. Be sure to verify the amplifier's minimum impedance requirements to ensure proper operation.


Does the black wire hook to brass terminal?

Yes-connect the black wire to the brass terminal and the white wire to the silver terminal.


How do you wire a citroen saxo ignition barrel?

To wire an ignition barrel in the Citroen Saxo, begin by disconnecting the wire at the negative terminal of the battery. A lead wire has to go to the ACC terminal on the ignition barrel. The starter relay wire goes to the ST terminal and the ignition wire is connected to the IGN terminal.


The line side of a switch is the?

The line side is where the source of the voltage is connected. The load side is where the device being switched is attached. In the case of a light switch the line side would connect to the house power and the load side would be the bulb. The switch is usually inserted in the line carrying the load (or black wires). As it it common to use 12-2 wiring to run from the device being switched to a switch on the wall, the return wire can be colored white. A electrician places an identification on the wire to signal that it is a "hot wire" even though it is white. Typically the electrician will wrap the white wire with black tape for about 1 inch to indicate this. A white wire is normally considered to be neutral if it is not identified as a "hot or load wire".


Can a wire connected across a battery's terminal produce current?

Yes