answersLogoWhite

0

Check your idle control valve on top of intake it has a small elect motor with a wire connected all fords build up carbon even have throttle sticking or hard to push slightly tap with screwdriver end while eng running then shift gears if this helps its temporary needs a 2 step fuel injection service where intake is flush out carbon and also cleans your 100k spark plugs i recomd this every 15k miles however im not a certified mechanic all though i play one on tv.lol

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

When your 1995 Chevy cavalier is shifted from park to reverse kinda fast it stalls out even if you shift it slow it stalls also when you shift from reverse to drive?

Sounds like a torque converter lock up solenoid.


When you switch on your 1986 Volvo 240 DL the engine runs but when you put the car in Drive and step on the accelerator the engine stalls - what is the problem?

If your Volvo is an automatic transmission try changing the fuel filter.


Your 88 1500 stalls when you are backing up It stumbles and stalls every time Sometimes when you put it in reverse it just sits there It won't move on it's own?

Sounds like you might have a torque converter problem. It could also just be that you need a new transmission. Does it shutter when you back up? What do you mean when you say that it stumbles?


Why does my 92 Cavalier with auto transmission run in park but when placed in drive or reverse it stalls It has to start in neuteral then shifted in to drive or reverse so it can run without stalling?

You have to unplug the electronic speedometer sensor located on the top rear of the transmission. It can be reached from above but its easiest to find with a lift. I have a 1990 cavalier and it has the same issue. I think its a problem with the sensor module that the speedo reader plugs into.


When Changing Gears your Chevy stalls out?

The year and engine info would help.


Why 1994 Cavalier stalls at light?

try the converter lock out sensor in the transmission


Yamaha grizzly 125 engine stalls in reverse?

It is a safety feature. You must pull in the left brake lever fully to engage reverse, if you try to put it into reverse without doing so, the engine will kill.


What causes an automatic transmission not to idle?

If you mean each time you engage car in any gear forward or reverse & it immediately stalls - you have a bad torque converter. Start engine, put foot on brake, put car in NEUTRAL, if it DOES NOT stall, but it does stall if you repeat this test when you put car in drive or reverse = bad torque converter - It's called a "stall test"


02 Pontiac Montana stalls when put in drive Also in 2ND Runs fine in reverse and low?

I have same problem.


Why does my car run in reverse and stalls in drive?

because your car has some problems i think you should buy another one :)


What damage is done when a manual car stalls?

When the car stalls out, depending on speeds, you can strip part of your transmission. (Basically break the tranny). Most stalls are stripping and what not when it comes to stalling, also I'm pretty sure you can short out some of the systems inside the vehicle.


Why does your 94 sunbird not downshift and stalls at stoplight?

If it's an automatic, you may have a sticking solenoid INSIDE the transmission.