its junk! crush it!
The ignition module uses the crank sensor to decide when to spark.
crank sensor or cam sensor
no... no spark???? module, crank sensor??? but no such saftey system. only on fuel, enertia switch
Ignition module, cam senor, crank sensor or bad computer
No spark? are you sure? then probably bad crank sensor, or ignition module.
Change crank shaft angle sensor ul get a spark
crank or cam sensor...did you already figure it out?
IF IT IS A 4 CYL YOU PROBABLY HAVE A BAD CRANK SENSOR OR IGNITION MODULE.
If on 2 cylinders, replace the coil, if on no cylinders, ignition control module, also could be crank sensor.
Depends on the motor, 4cyl or V6, but it could be the ignition module, or the crank sensor
It could be either the crank angle sensor or the distributor module. If it is the distributor module, you have to buy and install a re-man distributor.
1995 ford ranger 4wd cranks over but no spark, replaced crank sensor Check battery power to coil connector, if that is good coil can be tested w/multimeter.