What can be the problem with the overdrive light flashing on and off?
It's SUPPOSED to reset whenever you start your car. If not, see the dealer.
To reset the light, turn your ignition to on, then press the gas pedal 3 times, then start the car. To reset the light, turn your ignition to on, then press the gas pedal 4 times then you will hear a beep, then start the car.
To reset a motion light, first turn off the power to the light at the circuit breaker. Wait for a few minutes, then turn the power back on. This should reset the motion light and it should start working again.
to reset press and hold the odo reset and turn car on (do not start) and continue to hold for 10 seconds. light will go off
If you want the overdrive to be on, the light should be off on the dash. The picture on the button has the D in a circle with a line through it, just like a sign that says means "no smoking" & has the cigarette. Overdrive is always on when you start the vehicle.
To reset the maintenance light on a 2009 Acura MDX, start by turning the ignition to the "ON" position without starting the engine. Press the "Menu" button on the dashboard, navigate to "Vehicle Settings," and select "Maintenance Info." From there, choose "Reset" to clear the maintenance light. Turn off the ignition, and then start the vehicle to ensure the light is reset.
what do you reset the cehck engine light patriot manual transmission 2008? thanks for you support.
The overdrive warning light might start flickering when you are driving because of low transmission fluid. This light could also come on because of tension on the transmission while you are towing a boat or trailer.
Push and hold the odometer reset button while at the same time turning the ignitions switch on but do not start the engine. The light will reset after 5-10 seconds.
Push and hold the odometer reset button and then turn the ignition switch to the on position but do not start the engine. After around 5 seconds the light will reset.
it mean there is a hydraulic or electrical fault on the transmission
To reset the service CCR light on a 1991 Eldorado, disconnect the battery for 10 minutes. Reconnect it and start the car.