0
What else can I help you with?
Your 01 Chrysler sebring car wont start because of the alarm system how do you diable it?
Use your key in the drivers side door turn it both ways
Why wont your 2004 Chrysler sebring start up after you replace the battery?
Because you didn't charge the battery.
Your 2005 chrysler sebring wont start could it be the oil?
Unless you ran it out of oil and the engine is locked up, it is not the oil.
Why wont a 2002 Chrysler sebring turn over with the remote starter?
There are multiple problems that can result in remote start inoperable or disabled condition. These include OBD II problem codes and or starting/charging systems failures.?æ
How can you know about your transmission on a Chrysler Sebring 2002 it will go in reverse but it wont go in drive but it will sometimes when you play around with it what can that mean?
If the fluid fluid is full, you have an internal failure.
2004 Chrysler sebring 2.4L wont start checked timing belt and it wasn't problem?
If you don't have fire at the plug, change the crank sensor first, then the coil.
When you turn the key on a 2001 Chrysler sebring but it wont start have lights and have tried jumping it but that's not the problem What could be wrong?
If it does not turn over, but the lights work, you have a bad starter.
Why wont my Chrysler turn on but the battery and starter are good while ignition lights wont even turn on inside?
If the battery is good and the starter is good, then you must have a wire disconnected somewhere.
Does timing belt on 1997 Chrysler sebring make a whining sound when it is bad?
that's sounds more like the serpentine or power steering belt. Your timing belt is internal and you wont hear it but you will know when its broken... your car wont run.
Headlights in Pontiac Sunfire will not turn on?
headlights and dash lights in 2001 sunfire wont turn on.
How do you Enter radio code in 2001 diamante?
my 2001 diamante radio wont turn on after i put the code in
My 1998 Chrysler sebring turns over but wont start and has no spark?
check to see if the cam is turning. check coil by turning on and off the switch. have someone hold on to the big wire out of the coil.
