Poss plugged fuel filter or bad fuel pump With the car off: Unplug the MAF (Mass Airflow Sensor) its located next to the throttle body (its a little black box, follow the air intake pipe from the filter box towards the engine if you cant find it) Turn the car on, if it runs replace the MAF (~$120)
also your little display that shows messages and what not, that will say Clean Key - wait 3 min if the your passkey wasn't reading right Perhaps you see a Security Light flashing. Turn ignition on and leave on until security light stops flashing (up to 10 minutes) Do this a second time and again wait up to 10 minutes for security light to cease flashing finally a third time - after the 3rd time that the security light stops flashing ... Turn off iginition and try to start. Jon
The official documentation says:If you are prompted for a passkey, enter "0000" (for added security), or choose no passkey. This mouse will not work with any other passkey.
A hammer.
Only the factory PassLock / PassKey security system.
Ask the cops on the TV show "Bait car."
Passkey II can be reset based on the type of Truck you are looking at. You can usually reset it by the steps below. To determine if the passkey is your problem you need to know if the security light is flashing, solid, or out. Observe the Security indicator lamp in the instrument panel. Remove the key from the lock cylinder. - Security indicator should be Flashing when the door is open. - Security indicator should be Off when all the doors are closed. - If the Security indicator does not come On or go Off correctly, refer to the Content Theft Deterrent System diagnostic and repair information in the applicable Service Manual. With the Doors closed, place the key in the lock cylinder and turn to the Run position. Observe the Security indicator lamp. - Lamp is On and does not go Off however, the engine starts. This indicates that the Vehicle Theft Deterrent (Passlock) system detected a fault when the engine was running. - Lamp flashes On and Off. This indicates a problem has been detected by the Passlock(Passlock™) system and the engine may not start this key cycle, a current condition. If you determine that the Passlock is the issue, you need to do some web research on the "corrosion of the passlock system" GM had massive issueswith them and you may be able to get the answer there.
From everything I have read about this, if putting the jey in the 'ACC' mode for 10-15 minutes doesn't reset the system you will most likely have to have the key cylinder replaced by the dealer. The security Passkey system will probably have to be replaced or bypassed.
yes. you go to settings and then to security and set a password/passkey and then select messaging.
what is the numeric passkey for 2xxplantronics bluetooth
I need the passkey for my motorola hs850
AnswerYes...wait at least 3 mins before trying to start the car again when this happens.....because the car WONT start for at least 3mins when the passkey system is activated...security light keeps flahing when turn keyon ... won let car start
you work.