The speed sensor (transmission revolution sensor) is located on the left side of the bellhousing near the top. Access is through the driver's side wheel well. I'm at the wheel well and i cant see the speed sensor
The indicator was not or cant be reset.
its on the rear of the transmission, it cant be replaced by itself, its part of the trans
hi, you can erase the code with handheld diagnostic tool. if the code still cant clear after the new sensor, check if there is any related sensor problem.
Pretty sure you cant, the bronco is a short scale
you cant there is an electronic throttle position sensor that controls idle may be bad
YOU CANT ! Unless you change the computer to a speed density setup
no you cant to low in the back end
cant turn the key ignition on my 1996 aerostar ford
you cant
there were no 1996 jeep wranglers
cant