0
Can you install dual exhaust on a 1969 318 Plymouth Fury due to the fuel tank being offset?
Wiki User
∙ 12y ago
A good muffler shop can fabricate a dual exhaust system for that car.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Is Plymouth in the US?
Yes and no. There are cities named Plymouth in the US, Plymouth Massachusetts being the most famous. There is also a Plymouth in England. Plymouth Massachusetts was named after it.
What is the offset in a hexadecimal code?
The offset is usually the difference between the address of a module and the specific location being referenced.
I have kohler model #5rmoy61 and am looking for info on parts to install inside building and exhaust outside?
good doing their work is being responsible in work. you can get more information about it at serv.raratel.com
Oxygen sensor location for 1999 Plymouth Voyager bank 1 sensor 1 needed?
There are two oxygen sensors one is called the upstream oxygen sensor located in the exhaust manifold and one downstream directly behind the catalytic converter. I think the one you are looking for is mounted in the exhaust manifold sometimes referred to as bank 1 and sensor 1 being the first in the exhaust system. Hope this helps you.
Can you install dual exhaust on a 2005 Monte Carlo ls?
from what I understand you cannot reason being your os2 would confuse the computer sensor.The computer would read differently, unless there is a by-pass unit you can do.
How hot does car exhaust get?
Car exhaust can reach temps of 500 degrees F. With the hottest points being the exhaust manifolods/headers, and the catalytic converter.
What can cause minute oil droplets to come out of the exhaust?
incomplete combustion of the petrol in the cylinders which is then being released in the exhaust.
What were advantages of Plymouth colony being located on a bay?
Manufacturing biotchhhes!
Can you pumped exhaust steam directly to boiler?
No. Exhaust steam must be condensed back into water before being pumped back to the boiler. High pressure exhaust is often used to heat production or heating equipment, returned to a condensate tank then pumped to the D/A before being returned to the boiler. Low pressure (vaccuum) exhaust is condensed by a jet condenser or shell and tube condenser before being returned to the D/A.
What causes the door ajar light to stay on Plymouth Voyager?
The door being open.
Hardships in Plymouth?
Cold weather, not being familiar with the crops that produce in New England.
Why would oil pour out of the front when the gas peddle is being pressed in a 1993 Plymouth Voyager?
Probably "blow-by", which is caused when exhaust gasses that blow past the piston rings. When pressure builds up in the crankcase oil can be blown past the seals, gaskets and even the dipstick tube or oil fill cap. To check for blowby, remove the oil fill cap and start the engine to see if there is a quite a bit of exhaust gas blowing out.
