When the shifting linkage is disconnected the car will appear to go into gear but not move. The car will not move when the Transmission Fluid is low.
The car will not move when you put it in gear.
check motor mounts
Put your foot on the clutch, move the gear stick to neutral and then put your foot on the brake pedal
car starts but when i put it in gear it stop
Move the car at a walking pace, put the gearbox into neutral and move the high/ low stick from low to high.
Start the motor and then put it in gear. Point it down hill and release the brakes
Yes
slipping clutch? get a new one
If you have put it into gear and the car is not moving either your clutch is slipping or your clutch realese bearing is gone
Change the gearbox oil and see if that helps. If it doesnt it will be the gear selection sensor.
To put a Super Beetle in gear, first ensure the vehicle is at a complete stop and the clutch pedal is fully depressed. Move the gear shift lever into the desired gear position, typically first gear for starting. Gradually release the clutch while simultaneously applying gentle pressure on the accelerator to smoothly engage the gear. If done correctly, the car should begin to move forward smoothly.
well if you put the car in any gear and let out the clutch if you rev the engine and it dosent move or moves a little then it's the clutch but if it's a grinding noise and it doesnt move at all i'd say its the transmission my car was grinding and not moving and it was cause the spider gears were all busted and i had to rebuild my transmission