You need to rewire the entire car with a harness from a digital car. You have to remove the dash all the way to the firewall and replace with the digi dash and bezel. You'll need door latches from a digital car and the heater box needs to be from a digi, also. The heater control switch has to be changed to one from a digital car. It is a lot more than just pulling an analog cluster out and putting in a digital cluster. It's probably best to just get a digi car and restore it if you don't want a big project. Hope that helps!
To fix a digital odometer light in a 1998 Firebird, first check the fuse related to the instrument cluster, as a blown fuse could be the culprit. If the fuse is intact, inspect the instrument cluster for any loose connections or damaged components. You may need to remove the cluster and check the backlight bulbs or LEDs for failure. If the issue persists, consider replacing the entire instrument cluster or consulting a professional for further diagnosis.
An instrument cluster is what displays basic information in your car. Information like the speedometer, fuel level, care temperatures... etc. Cars nowadays are mostly made with a digital instrument cluster.
search for instrument cluster repair in search engine
yes, infact the newer ones have one
you need a new cluster, from the dealer, usually about $250- 300
To replace the digital instrument cluster on a 1989 Chevy S10 Blazer, first disconnect the negative battery cable to ensure safety. Remove the dashboard trim and any screws or bolts securing the cluster; carefully pull the old cluster out. Disconnect the wiring harness and any attached cables, then connect the new cluster by reversing the disassembly steps. Finally, reattach the dashboard trim and reconnect the battery.
You will need to remove the instrument cluster board. To do that, remove the trim piece around the instrument cluster, then carefully pull the instrument cluster out of the dashboard. Note that the instrument cluster plugs in to a socket in the dashboard, so be careful as you remove the circuit board so that you do not damage the plug. Once the instrument cluster is out, replace all bulbs. They twist to remove, and if the odometer bulb has failed, the others are getting old too. It might be best to replace them all to avoid future problems.
EBAY AND FROM THERE YOU SHOULD BE ABLE TO FIND IT WITH ALL THE LINKS ON THE WEB.
To read the odometer on a 1991 Ford Ranger, locate the instrument cluster on the dashboard. The odometer is typically a digital display or a mechanical roll-over type, showing the total mileage. If it's a mechanical type, look for the small numbered dials; the numbers will rotate to indicate the mileage. For digital displays, simply glance at the screen to see the mileage reading.
A digital cluster may not directly fit a 1991 Chrysler LeBaron without modifications, as the original instrument panel design and wiring are tailored for analog gauges. The compatibility would depend on the specific digital cluster's dimensions, electrical connections, and the vehicle's existing wiring harness. Custom adapters or wiring may be necessary to install a digital cluster successfully. It's advisable to consult with a specialist or reference vehicle modification forums for specific guidance.
Instrument Cluster Bad, Dealer Repair Only
If the instrument panel wonÕt light up, there may be a problem with the wiring. There may also be some fuses that are out.