To change the starter on a Dodge Stealth, first disconnect the negative battery cable and remove any necessary components for access, such as the air intake or engine cover. Locate the starter, which is typically situated near the transmission. Unbolt the starter, disconnect the wiring harness, and install the new starter by reversing the removal process. Finally, reconnect the battery and test the new starter to ensure proper functionality.
on the starter its self>>>>JAC
To change the starter on a 1991 Dodge Stealth, first disconnect the battery to ensure safety. Then, remove the protective cover if present, and unbolt the starter from its mount, which typically involves accessing it from below the vehicle. Disconnect the wiring harness and the positive cable from the starter. Finally, install the new starter by reversing the steps, ensuring all connections are secure before reconnecting the battery.
Yes.
right beside the tranny. its bolts on to it
yes
Look at the rear lower end of engine--follow + battery cable
The Starter for Dodge Stealth R/T's are located on the Front Right hand side of the car, it is actually attached to the front bottom of the Transmission next to the exhaust pipe and the front motor mount. It should have a Red rubber cover over the terminal as if it was a Battery. GSM
Take it to the Dodge Dealership and let them either change the sensor or reset the system for you.
Yes it will.
dodge stealth is same as 3000gt stealth rt tt is same as 3000gt vr4
The solenoid is attached to the starter. Replace the starter.
WHERE DO YOU CHECK THE FUEL PRESSURE ON A 1991 DODGE STEALTH