0
What else can I help you with?
Where is the door lock remote control receiver for a 1997 Chevy Astro Van?
The door lock remote control receiver for a 1997 Chevy Astro van is located inside the cabin. it is found on the right kick plate.
How can you get a jammed driver side door lock back into the open position when the door is open on a 1998 Chevy astro van when master lock and keys and pliers don't budge it?
== == Pull on the inside door handle and it will release it so you can reset the mechanism with your fingers. This solution also worked on a Chevy Astro van 1990.
How do you change the lock on a 1997 Chevy silverado truck driver door with power locks?
Should have access after removing inner door panel
Where is the automatic door lock fuse on a 2006 Chevy Cobalt?
Inside of car, passenger side on the side of the console trim casing. Pull panel off to access door lock fuse.
Where is the power door lock relay on a 2001 s-10 blazer?
The 2001 Chevy S 10 Blazer power door lock relay switch is located inside of the drivers side door. You will need to remove the drivers side door panel in order to access the door lock relay switch.
Where is the door lock actuator on an 02 Chevy tralblazer?
You will have to remove the door panel. And it will be mounted over by the door lock on the inside of the door.
How do you install lock cylinder in 1986 Chevy truck?
Ignition Lock? or Door Lock?
Where is the door lock module in a 98 Chevrolet Silverado 1500?
Where is the door lock module for 98 chevy Remote
Passenger door wont open from outside on a 1989 Chevy pickup?
Lock mechanism probably frozen or broken--you should be able to access by removing inner door panel to determine problem
Jeep rear door wont close how do you release lock?
Access in rear door panel, allows you to lock/inlock rear door.
Where is the door lock relay located in 1993 Jeep Grand Cherokee Limited?
It depends, some are in the door, some are in a fuse box.
How do you replace door handle on a Chevy Astro van?
To replace the door handle on a Chevy Astro van, first, remove the door panel by unscrewing any visible screws and gently prying off clips. Once the panel is off, disconnect any wiring attached to the power lock or window controls. Next, locate the door handle mechanism, unbolt it, and carefully detach the old handle. Install the new handle by reversing the steps, ensuring all connections are secure before reattaching the door panel.
