To clear a hard code. You need a scanner to connect to the vehicles ECM.
It is the sensor in the outlet of the catalytic converter.
There is one on each side of the catalytic converter.
In the exhaust manifold at the firewall (rear of engine).
The 2004 Dodge Intrepid oxygen sensor can be found on the back of the air cleaner housing. Remove the wiring harness. Remove the oxygen sensor retaining screws. Reverse the process to install the new oxygen sensor.
Screwed into the exhaust system. Either in the manifold or the pipes.
In 2004, the Dodge Cummins Diesel was not equipped with an oxygen sensor. The 2007.5 and newer Cummins 6.7 liter Bluetec diesels have an O2 sensor in the downpipe. Typically, only particulate filter equipped diesels have O2 sensors.
It only has one, and it is in the rear exhaust manifold.
On a 2004 Dodge 2500 with a 5.7-liter engine, Bank 1 Sensor 1 (upstream oxygen sensor) is located on the passenger side of the engine. Specifically, it is positioned in the exhaust manifold, before the catalytic converter. This sensor monitors the oxygen levels in the exhaust gases to help optimize engine performance and emissions.
On a 1993 Dodge Shadow ES with a 2.5-liter engine, the oxygen sensor is located on the exhaust manifold or in the exhaust pipe just downstream of the manifold. It is typically positioned before the catalytic converter. To access it, you may need to raise the vehicle and remove any necessary components for better visibility.
it is located just behind where the exhaust pipes "y" together
where is the camshaft sensor on a 2006 dodge ram 5.7 litre
No