0
What else can I help you with?
Where is Bank 1 Sensor 1 in a 3.3L Dodge engine?
On the Minivan it is the sensor in the exhaust on the back of the engine in the exhaust manifold.On an Intrepid/LHS/Concorde it is the pass side above cat oxygen sensor.On the Minivan it is the sensor in the exhaust on the back of the engine in the exhaust manifold.On an Intrepid/LHS/Concorde it is the pass side above cat oxygen sensor.
How do you replace a map sensor on 2004 intrepid?
how to replace a map sensor on a 2004 dodge intrepid.
Where is the oxygen sensor located in a 2002 Dodge Intrepid?
There are four oxygen sensors on a 2002 Intrepid. There is one before, and one after the catalytic converter on each side of the engine.
What does a oxygen sensor do on a dodge intrepid?
It determines, in real time, if the air fuel ratio of the engine is rich or lean.
Where is the oxygen sensor located in a 1996 Dodge Intrepid 3.5?
It is located on the exhaust, maybe a foot or so from the engine. which side?
What is code PO159 for 2002 intrepid?
defective oxygen sensor
Where is the oxygen sensor on a 2000 Dodge Intrepid?
If I knew I would not ask.
Where is oxygen sensor in 1998 Dodge Intrepid?
There are 4 in the exhaust system.
How do you replace oxygen sensor in Honda Odyssey?
To replace the oxygen sensor on a Honda Odyssey, first unscrew the sensor. Then use a 22 mm socket or 7/8 inch wrench to replace the oxygen sensor.
Will replacing the oxygen sensor stop my 1999 Intrepid engine from smoking?
change oil and add thicker oil with lucus oil.it is do to needing a ring job done.
Where is the camshaft sensor located on a 2004 Dodge Intrepid 2.7 engine?
Front left of engine.
How do you replace oxygen sensor on Dodge Magnum 3.5L?
To replace the oxygen sensor on a Dodge Magnum 3.5L, first, ensure the engine is cool and disconnect the negative battery cable. Locate the oxygen sensor, which is typically found on the exhaust manifold or downstream in the exhaust system. Use an oxygen sensor socket or a wrench to unscrew the old sensor, then install the new sensor by threading it in and tightening it securely. Finally, reconnect the battery and check for any error codes before starting the engine.
