It just uses standard 80 or 90 weight... I'd recommend GM Syncromesh, a synthetic oil especially for GM vehicles. It's a little more expensive, but lasts longer. And if your changing the Transmission Fluid in a 5-speed, I'd recommend nothing else. However, if your a bit strapped for cash, just go to your local auto parts store and ask for some 80,85, or 90-w50 (commonly called 80,85, or 90 weight). You'll need about one and a half to two quarts. I might also add that it's the same weather front or back diff. or auto or manual trans. Josh 95 Geo Tracker TBI 2x4 5-speed w/ soft top
How cha~ge oil tra~smisio~ of a geo tracker 95
5w-30
The Geo. Tracker OIl Cap. is 41/2 Qts. of oil--unless you use a larger oil filter such as a Fram ph3400 then it becomes 5 Qts. Al S.
Hi, The oil capacity for the 1994 Geo Tracker with the 1.6 engine is 4.5 quarts with the filter. Steve H.
it should be 4 to 5 quarts
front and rear differentials that is if it is a 4x4
4 quarts with original filter 4.3 if installing a fresh oil filter
The Geo Tracker with a 1.6-liter engine typically holds about 4 quarts of oil, including the oil filter. It's important to check the owner's manual or the specifications for your specific model year to confirm this, as it can vary slightly. Always ensure to check the oil level after filling to avoid overfilling.
YES, IT WILL IT WILL FIT IN THERE PERFECTLY WITH NO PROBLEMS AT ALL! I HAVE BEEN CHANGING GEO ENGINES FOR 25 YEARS I HAVE PUT A 89 GEO TRACKER ENGINE INTO 91 GEO STORMS LOTS OF TIMES. WHEN CHANGING ENGINES ALWAYS CHECK YOUR MUFFLER BELTS AND MAKE SURE YOU HAVE PLENTY OF OIL, TRANSMISSION FLUID, BLINKER FLUID, AND REAR END OIL. ALWAYS CHECK YOUR SEALS ALSO. SINCERELY CHUCK DAVIS
if 16v ? yes. the 96 to 95 direct (long block yes, not manifolds) 95 to 96 , you must swap oil pump and pan. with CKP sensor. see my profile links.
There should be a cap on the back of your engine above the transmission, in big bold letters is the word oil, twist and fill. :)
The 1993 Geo Tracker typically requires about 4 quarts of oil for an oil change with a filter replacement. If you're only changing the oil without replacing the filter, it may take slightly less, around 3.5 quarts. Always check the owner’s manual for the specific requirements for your vehicle, as variations may exist based on the engine type.