Disable seat belt chime in a Jeep Liberty?

Answer 1

ProcedureThe Enhanced Warning System (BeltAlert) can be enabled

or disabled by your authorized dealer or by

following these steps:

NOTE: The following steps must occur within the first

60 seconds of the ignition switch being turned to the ON

or START position. DaimlerChrysler does not recommend

deactivating the Enhanced Warning System

(BeltAlert).

1. Turn the ignition switch to the OFF position and

buckle the driver's seat belt.

2. Start the engine and wait for the Seat Belt Warning

Light to turn off.

3. Within 60 seconds of starting the vehicle, unbuckle

and then re-buckle the driver's seat belt at least three

times within 10 seconds, ending with the seat belt

buckled.

NOTE: Watch for the Seat BeltWarning Light to turn on

while unbuckling and off while re-buckling the seat belt.

It may be necessary to retract the seat belt.

Answer 2

My seat belt alarm goes off even with both seat belts buckled properly. Following the procedure to a T, doesn't work either. I wait 30-60 seconds, plus another 10 minutes, and the harnessed man symbol never dims out. Just stays lit.