take all screws out even the one behind the handle then pop the panel and lift up
Mopar2.21984 says: Not exactly. My '95 GTC has a speaker grill cover on each door that can be removed with a machinists scribe or a flatip screwdriver. The grills are secured to your door by only 4 metal clips. When removed - the grill - you now only need remove 4 hexhead nuts, pull out speaker and disconnect the wire. Have fun!
The rear speakers in a Toyota solara convertible, you must first remove the existing speakers by removing the cusions from the back of the seats and then accessing the main wire panel to discconect them.
Show removel of trunk lock 1993 chrysler lebaron
Inside of the car. Remove the glove box.
In my 1991 lebaron convertible the front door speaker grilles just pop off( no need yo unscrew door) on the back u take a Phillips head and unscrew the 2 screws and it comes out from the back (located under the black fabric with top down
remove the grills connect two 3 1/2's (the left will fit VERY TIGHT) but it replaced cardboard and wired into pre made slots for the speakers very easy in the end.
Counter clock wise to loosen.
To replace the back speakers in a 2006 Acura TL, remove the SRS housing on both sides and the back panel of the speakers. Remove all wiring attached to the speakers and replace.
Gently pry off plastic covers in door They are held in by clips underneath are speakers held in by 2 or 3 screws remove speakers. Wires should be snap in plugs remove by unsnapping plug-in.Connect snap-in plug wires to new speakers Place new speakers in door slot for speakers,screw back in ,remount cover back in place
remove back up tire in back right behind seat
No, you do not have to remove the engine to replace a radiator hose.No, you do not have to remove the engine to replace a radiator hose.
To remove the rear speakers from a 1988 Chevy Cavalier Z24 convertible, first, ensure the car is turned off and disconnect the negative battery terminal for safety. Remove the rear speaker grilles by gently prying them off with a flat tool. Next, unscrew the speakers from their mounts and carefully disconnect the wiring harness. After that, you can lift the speakers out of their locations.
To replace the body control module (BCM) in a Chrysler LeBaron convertible, first disconnect the negative battery terminal to ensure safety. Locate the BCM, typically found under the dashboard or near the steering column. Remove any covering panels, disconnect the wiring harnesses, and unbolt the module from its mounting bracket. Install the new BCM by reversing the removal steps, reconnect the wiring, and reattach any panels before reconnecting the battery.