No. There are 2 U joints, 1 front and 1rear. If they are the factory U joints they are sealed with a plastic meaning no clips on driveshaft side. If you are not of high mechanical ability I would take it and have it done.
You have to replace the whole drive shaft.
how do you replace the drivers side drive shaft and cv joint?
drive universal jount
very carefully!
not possible. the whole drive shaft needs replaced.
To replace the CV joint on a Citroën C4, begin by safely lifting the vehicle and removing the wheel. Disconnect the lower ball joint and the drive shaft from the hub assembly, then slide the shaft out of the transmission. Remove the old CV joint from the drive shaft, replace it with the new joint, and reassemble everything in reverse order, ensuring all components are securely fastened and torqued to specification. Finally, test the vehicle to confirm proper installation and operation.
It's part of the driveshaft outer cv joint. Replace the shaft as per 2002 Clio 1.5dci
You probably mean U - joint (universal joint)! Located at each end of drive shaft or axle and possibly in the middle of drive shaft.
you need a set of pliers a hammer and a big socket that will fit in the hole where the u joint is. take the pliers sqeeze the ring together that's in it pull out. then take your socket and hammer and and hit the u joint out of the casing.
It's usually much more inexpensive to replace the entire drive shaft than to repair a worn cv joint. The new drive shaft will come with new cv joints and new boots.
You probably mean U - joint (universal joint)! Located at each end of drive shaft or axle and possibly in the middle of drive shaft.
tool for drive shaft