answersLogoWhite

0

the filter is easy to change with no worries. you squeeze the white or coloured clips on each pipe to unlock them from the top of the old filter. but to bleed the air out,you need a primer pump. which you connect to the arrowed outlet from the filter to the diesel pump. in other words the arrowed outlet showing on the filter. you prime up you fuel till its free from air bubbles. normally a quarter of a litre. then you get ready and quickly swap the primer pipe with the outlet pipe the run up your engine for a few mins. Thanks you I'll be attempting this tomorrow so I will let you know how I get on!

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

If you change injectors on a transit connect do they have to be reprogrammed?

Yes, when you change the fuel injectors on a Ford Transit Connect, they typically need to be reprogrammed. This is necessary to ensure that the engine control module (ECM) can correctly recognize the new injectors and adjust fuel delivery accordingly. It’s recommended to use a diagnostic tool to perform this reprogramming for optimal performance and efficiency.


What mileage for cambelt change on ford transit connect 2006?

45k Ok they have a belt and chain which both need to be changed 150,000 miles or 10 years,on my 3rd connect so know a little about them..


What time to change timing belt of ford transit connect 1.8?

Any time, as long as you don't disturb the neighbours by changing it in the early hours of the morning.


How do you change driveshaft gaitor on Ford Transit Connect?

To change the driveshaft gaiter on a Ford Transit Connect, first, lift the vehicle and secure it on jack stands. Remove the wheel and brake components to access the driveshaft. Carefully detach the old gaiter by cutting it away, clean the area, and then slide the new gaiter onto the driveshaft, securing it with clamps. Reassemble the brake components and wheel, then lower the vehicle to the ground.


How do you fix a ford transit connect starter motor?

change it for a new one,not worth the hassle of trying to repair it! £65 plus vat. 2 bolts job done!.


How do you change a clutch on a transit connect van?

Remove front driver seat . Disconect battery . Remove wheels . Take cluch rod off . Clutch falls out . Refit as removed


Do you need to change flight in transit?

no


When do you change the timing belt on your 1999 ford transit 100?

when do i change the timeing belt on my 1999 ford transit 100 2.5d


How do you change sump gasket on transit connect?

To change the sump gasket on a Ford Transit Connect, start by draining the engine oil and removing the oil pan. Clean the mating surfaces thoroughly to ensure a proper seal and remove any old gasket material. Apply a new gasket or gasket maker as specified, then reattach the oil pan and tighten the bolts to the manufacturer's torque specifications. Finally, refill the engine with oil and check for leaks.


How do you change heater on a Ford Transit Connect?

To change the heater on a Ford Transit Connect, first, ensure the vehicle is turned off and cool. Disconnect the battery, then remove the dashboard and any necessary panels to access the heater core. Drain the coolant, disconnect the heater hoses, and remove the old heater core. Install the new heater core by reversing the steps, ensuring all connections are secure before reassembling the dashboard and filling the coolant back up.


Can paragard change your period?

Paragard may change the flow, cramping, or duration of bleeding but not the timing of bleeding.


Do south africans need a transit visa for turkey?

Yes, South African passport holders require a transit visa for Turkey if they plan to exit the international transit area of the airport. However, if they remain in the transit area and do not pass through immigration, a visa is not necessary. It's important for travelers to check the latest requirements and regulations before their journey, as these can change.