0
Add your answer:
Earn +20 pts
Where is the trailer brake wire 2000 silverado?
If you have the towing package it is in the 7 pin blade connector next to your receiver hitch. and that runs back to underneath your dash for brake controller hookup. 2000 Chevy Silverado LT Ext Cab 4 dr 5.3L 4x4 Z71
What if your 94 Chevy Silverado always blows the turn signal fuse when you shift into reverse?
the wire in the steering column is shorting out
Where can you find a radio wiring diagram for a 2000 Chevy Silverado?
left front speaker wire brown is positive.
Cost of tune up on 2000 Buick Lesabre?
Irridian? plugs, wire package, diagnostic...#335.02 :(
What color is the mute wire for 2004 Chevy Silverado?
What color is the mute wire for 2004 chevy silverado?
2000 silverado fuel level sensor not working?
Could be a fuse, relay, rheostat (the wire winding inside housing of the sender unit), a bad connector, bad wire.
4.3 won't start when wet out in 2000 silverado?
Cracked Distributor Cap/Cracked and Worn Plug & Coil wire. Replace them all.
How can you add heated mirors to your 2000 Silverado?
Buy oem or aftermarket heated mirror and wire them to your rear defrost or create a fused circuit for the mirrors. My 2000 Chevy Silverado LT Ext Cab 4 dr 5.3L 4x4 Z71 has stock heated mirrors.
Why is your 2000 Chevy silverado fuel gauge not working right?
a mechanic told me that the fuel pump has a loose ground wire low fuel to current fuel level over and over again. my 2000 did that
What color is the reverse wire for a 96 Chevy Tahoe where is it located?
The 1996 Chevy Tahoe reverse wire is light blue. You can find the reverse wire inside of the steering column.
What color is the ground wire for a Chevrolet silverado 2002?
where is the ground wire for the brake and turn signals on 2002 silverado chev pu. also do you have a copy of the wiring>
How do you replace the alternator on a 2000 Silverado 1500?
i don't have a 2000 but it should be the same as any vehicle: disconnect your battery. disconnect the serpentine belt. you need to put a socket wrench on the front of the tensioner in order to slacken the belt. disconnect the wire connectors on the alternator. unbolt the alternator. install is reverse of removal. you may or may not have to transfer the pulley from the old one onto the new one.
