Remove the bolt holding it in Place
The 1995 Ford Taurus front bumper is held in place by four retaining bolts and six retaining clips. Remove the retaining bolts and pry outward on the retaining clips.
i beleave there are clips under the seat you might have to take the seat out and tip it over and there should be plastic clips that you can remove
To remove the washer bottle from a Ford Transit Connect, first, disconnect the negative battery terminal for safety. Next, remove any necessary components obstructing access, such as the front grille or other panels, depending on the model year. Disconnect the washer fluid hoses and electrical connectors from the bottle, then unfasten any mounting bolts or clips securing the bottle in place. Finally, carefully pull the bottle out and replace it as needed.
Remove the negative terminal first and connect it back last.
To replace the gas lock door on a Ford Transit Connect, first, ensure the vehicle is parked and secure. Remove any screws or clips holding the gas door in place, then gently pull the old door away from the hinge. Align the new gas door with the hinge and push it into place, making sure it clicks securely. Finally, reattach any screws or clips, and test the door to ensure it opens and closes properly.
You need fuel line clips that release the spring inside the clips.
The 1986 Ford F1 50 pickup truck dashboard is held in place with six retaining bolts and 10 retaining clips. Remove the retaining bolts and pry outward on the retaining clips.
It was easy,remove bat, unplug wiring,pull 2 clips and push out the bottom mounting plastic and remove assembly.save clips for use on the new assembly
The 1998 Ford Ranger door panel has eight retaining clips. Pry outward on each retaining clip. Remove the two door handle screws.
detach the bulbs and remove the clips behind the headlight assembly
To replace the radio on a Ford E350, first remove the bezel from around the existing radio. Then, release the clips on either side of the radio and remove it from the dashboard. Then, release the wiring. Place the new wiring on the replacement radio and insert it into the dashboard. Lock the clips in place and replace the bezel.