0
What else can I help you with?
On a 98 Ford 150 4x4 do you have to remove the torsion bars to remove the transmission and transfer case?
Yes you do have to remove the bars or at least the torsion bar cross member and to do that you either need the otc tool or use a two jaw puller make sure to measure the bolt height before you start and set it the same they control your ride height
How do you open a trunk of A 2005 Ford Fusion without the key?
Ford didnt make a Fusion till 2006
How do you remove the license plate bulbs on a 1999 Buick Le Sabre?
If you can not remove fasteners from outside of trunk you must make a cut-out inside of trunk so you can get your hand to access bulbs.
Can you remove the back seats to get in the trunk?
The year, make and model info would help.
How do you remove trunk lock on 2001 Camry?
To remove the trunk lock on a 2001 Toyota Camry, first, open the trunk and locate the lock mechanism. Disconnect the electrical connector by pressing the tab and pulling it out. Next, remove the screws or bolts securing the lock assembly to the trunk lid, then carefully pull the lock out of its housing. Make sure to keep track of any screws or clips for reinstallation if needed.
Is it easy to remove a torsion bar on a 1995 Ford Explorer to change lower control arms?
MOST Torsion Bars have an adjustment bolt 2 set the ride height-IF so-back off the adjustment until u can move the arm by hand up & down-MAKE sure u measure the ride height B 4 U start & measure the amout of threads on the adjustment & B Very Careful that ALL the TENSION is OFF>
Where is the fluid cylinder for the convertible top on a 1991 Ford Mustang?
The fluid cylinder for the convertible top on a 1991 Ford Mustang is typically located in the trunk area, near the driver's side. It is part of the hydraulic system that operates the convertible top. You'll need to access the trunk and possibly remove some trim or covers to reach it. Make sure to check the fluid level and connections if you're experiencing issues with the top operation.
How do you make sentence trunk?
To make a sentence trunk, you can start by identifying the main idea of the sentence and keeping only the essential information. Remove any unnecessary words or phrases that don't contribute to the meaning of the sentence. Keep the sentence clear, concise, and focused on the central message.
What grade of steel is used to make a torsion bar?
300M (ww.ovako.com)
How do you remove the inside part of the trunk from a 2004 Honda Odyssey?
It isn't difficult to remove the inside part of the trunk from a 2004 Honda Odyssey. However, you will need the repair manual for your specific car. Make sure to follow the directions so you don't break the trim panel.
Is there an inside trunk release for a 4 door 1989 Ford Tempo?
Yes. Look inside the glove compartment. There should be two buttons. The yellow one is your trunk release. Make sure the key is in the ignition, also.
How do you remove a factory rear spoiler on a 350z?
To remove a factory rear spoiler from a Nissan 350Z, start by opening the trunk and locating the bolts securing the spoiler to the trunk lid. Typically, you'll need to remove the trim or access panel in the trunk to reach these bolts. Use a socket wrench to carefully unscrew them, then gently lift the spoiler off the trunk. Make sure to clean any adhesive residue left behind and consider filling any holes if you're not replacing the spoiler.
