I would call a GM dealer's service center or a brake shop to find out for sure, but I know that if the ABS system isn't working, your brakes won't be affected.
You can just override the abs by disconnecting the system. Then you will just have a regular braking system where you have to pump your brakes when necessary. For me, it beat paying the $1,500 to replace the abs system. Hope that's helpful enough.
It's attached to the master cylinder
At least the slave cylinder. The clutch master cylinder can be replaced at any time.
Master Brake cylinder replaced and lines bled-how long?
after the clutch master cylinder has been replaced.
The Slave Cylinder and the Master Cylinder control totally different systems. The Slave has to do with the clutch, and the Master has to do with the brakes. They have nothing in common.
If you did not bench bleed the master, you need to do that.
A master cylinder should be replaced when it can no longer provide the pressure needed for the brakes to operate. You can tell it is failing when the pedal becomes soft.
The clutch master cylinder on a Chevy S10 is replaced by disconnecting the metal lines, unscrewing the retaining bolts, and removing it from the housing. A new master cylinder can then be put into place and reattached.
It means your master cylinder needs to be replaced or rebuilt. The seals inside the cylinder can go bad and cause this to happen.
Most likely there's not enough brake fluid or your master cylinder is ready to give out.
== == == ==