Yes, the wiring harness from a first-generation Mitsubishi Eclipse (1995-1999) is generally compatible with the 1993 Eagle Talon, as both vehicles share the same platform and many components due to their joint development by Mitsubishi and Chrysler. However, there may be some differences in specific connectors and features depending on the trim and options. It’s advisable to verify the specifics of the wiring and consult wiring diagrams for both vehicles to ensure compatibility.
walmart
In the Haynes Repair Manual, book number 68031 for 1995-2001 Mitsubishi Eclipse and Eagle Talon. Look in Chapter 12 page 39, wiring diagrams 1 and 2.
The easiest way to do this would be to pull the 1.8 and drop in a 2.0 turbo from a 1st gen DSM (Talon, Eclipse or Laser). It should fit just fine, and the motor mounts should be the same. Be sure to get the wiring harness and ECU from the donor car!
just get a 6bolt 4g63t have to get the wiring harness transmission ecu it's just best to buy a tsi/gsx/gst you'll spend to much money on it
Yes they will, eagle talon headlights are interchangeable between 95-98 , 95-96 eclipse headlights are identical as well. 97-99 eclipse headlight are revision b and wont fit properly
No
crankshaft position sensor wiring eagle vision
To replace the starter in a 1993 Eagle Vision, first disconnect the negative battery cable to ensure safety. Remove the starter by unbolting it from its mounting, typically involving a few bolts and disconnecting the wiring harness. Install the new starter by reversing the removal process, making sure to secure all bolts and reconnect the wiring. Finally, reconnect the battery cable and test the new starter to ensure proper operation.
No, it is not standdard
To change the ignition key switch in a 1995 Eagle Summit, first disconnect the negative battery terminal to ensure safety. Remove the steering column cover by unscrewing the screws and carefully pulling it apart. Next, locate the ignition switch, disconnect the wiring harness, and unscrew the switch from its mounting. Finally, install the new switch by reversing the steps, reconnect the wiring, and reassemble the steering column cover.
1990-1999 Talon/Eclipse=5x114.3 (4.5)
1995-half of 1999