It's in the passenger side footwell underneath the glove box. Pull away the piece of carpet covering it and hey presto.
The heater blower resistor on a 2004 Ford Fiesta is typically located behind the glove compartment. To access it, you may need to remove the glove compartment door by detaching any screws or clips. Once the glove compartment is out of the way, the resistor will be mounted on or near the blower motor, usually secured by screws.
How do you remove the dashboard on a 1996 Ford Fiesta
how is it my heater control on my ford fiesta flight 1998 only works on no. 4
where is the blower motor resistor located on a ford e250 2001
Get down in the drivers footwell and look to the left behind the clutch where the central console is. You will have to remove that vent kick-panel to get to the resistor. It uses two torx screws and is a simple 5 minute job. Hope that helps. A.Macdonald
In a Ford Fiesta, the heater fuse is typically located in the fuse box under the dashboard on the driver's side or in the engine compartment. To find the exact fuse, refer to the owner's manual, which contains a fuse diagram indicating the specific location and number of the heater fuse. Always ensure the vehicle is turned off before checking or replacing any fuses.
under the hood hinge on passenger side in the corner going into the cab at an angle
The blower motor, on a Ford fiesta, can be located on the firewall in the engine compartment. The blower motor will be on the passenger side of the firewall.
heater blower resistor has to be replaced. you have to remove glove boxthe resistor is to the right of the heater blower moter
Defective heater resistor pack.
If the heater motor in a 1997 Ford Fiesta only works on the highest setting (4), it is likely due to a faulty blower motor resistor. The resistor controls the different speeds of the blower motor, and if it fails, it may only allow the highest speed to function while disabling the lower speeds. Additionally, issues with the wiring or a faulty switch could also contribute to this problem. Checking and replacing the blower motor resistor is usually the first step in resolving this issue.
Resistor pack